Idiomas disponibles
Idiomas disponibles
2.Product and mounting dimension:
I
J
K
Ref.
A
B
C
D
E
F
The outside diameter of the toilet drain outlet: 95mm / 3.7";
The inner diameter of the toilet drain outlet: 87mm / 3.4"
3.Installation
Note:
• Be sure foot pedal, when pressed, touches same at surface on which toilet is installed.
• Ensure water supply pressure is no more than 0.4Mpa.
• Hot water more than 40 degrees is forbidden.
1. To replace an older toilet, turn o water supply to toilet. Remove and drain water
supply line. Remove toilet hold-down bolts/screws. Remove toilet from oor. Remove
and discard old ange seal and hold-down bolts. Verify center of oor ange is at least
200mm/7.9" from back wall(Fig.1).
2. If installing a new oor ange, make certain that toilet mounting holes are located at
the correct angle (Fig.1). Floor ange must be secured to oor with a minimum of four
screws. Insert two supplied T-bolts into slots in oor ange(Fig.2).
3. 3)Verify that oor ange seal is installed on base of toilet. Carefully set toilet over oor
ange. Align holes in toilet base with T-bolts as toilet is lowered onto oor ange.
4. Install oor mounting nuts onto T-bolts. When tight, base should be securely attached
and at against oor. Attach bolt covers onto nuts
5. Connect water supply line to ½ inch water inlet and turn on water supply line. (Fig.3)-
Flush toilet several times and check for leaks.
L
M
Description
390mm / 15.4"
500mm / 19.7"
233mm / 9.2"
485mm / 19.1"
380mm / 15.0"
890mm / 35.0"
N
?
!
G
Ref.
G
H
I
J
K
L
www.serenelifehome.com
O
Description
Minimum: 200mm / 7.9"
Minimum: 200mm / 7.9"
Minimum: 200mm / 7.9"
170mm / 6.7"
102mm / 4.0"
210mm / 8.5"
P
C
3
