Idiomas disponibles
Idiomas disponibles
EN
A -
Adjustable headrest
B -
Shoulder belt slot
C -
Shoulder pads
D -
5-point Harness
E -
G-CELL
F -
Harness buckle
G -
Harness adjuster button
H -
ISOFIX release handle
I -
Harness adjuster strap
J -
Headrest adjustment handle
K -
Top Tether
L -
Storage compartment for the manual
M -
ISOFIX connectors release button
N -
ISOFIX connectors
O -
Crotch pad
P -
Recline handle
SAFETY
The Maxi-Cosi Titan S / S Comfort i-Size is
intended for car use only.
• The car seat is developed for an intensive use of
approximately 12 years.
• Do not use any load bearing contact points
other than those described in the instructions and
marked in the child restraint.
• Do not use before the child's age exceeds 15
months.
Maxi-Cosi Titan S / S Comfort i-Size in the car
• Before buying this product make sure the car seat
is compatible with the vehicle it is to be used in.
• After purchasing, install the seat in your vehicle.
If you encounter any installation problems, contact
your distributor immediately (prior to use).
I
58
Titan S i-Size & Titan S Comfort i-Size 76-150 cm / 15 M – 12 Y
• It is recommended to adjust to full recline position
before ISOFIX system installation. After correct
installation of the ISOFIX connector and top tether,
adjust to the proper recline position for your child.
WARNING:
• Check that the child seat is properly installed. It
is important for your child's safety that you fit the
belt correctly. The vehicle belt must be fixed along
the appropriated markings/positioning points on
the seat.
Please also read the label on the side of the car
seat. Never fit the belt in any way other than as
shown.
• When the car seat is installed on the front
passenger seat, we recommend to switch off the
front passenger airbag and place the passenger
seat in the rearmost position.
• Use the car seat only on a front-facing seat that
is fitted with an automatic or static 3-point belt
that has been approved according to the ECE R16
standard or similar. Do NOT use a 2-point belt.
• When installing the car seat, spaces between
the base of the car seat and the vehicle seat
are possible depending on the position of the
anchorage points within the vehicle.
ATTENTION:
• For usage in ISOFIX use the fitting clips for
lower anchorage to the vehicle are not sufficient.
It is essential to fix the "TOP TETHER" to the
upper anchorage point recommended by the car
manufacturer.
I
Maxi-Cosi
