Idiomas disponibles
Idiomas disponibles
1:7;1_-_:_Je_.'l
Bri_s
& Stratton Power Products Automatic
Transfer Switch
Installation
and Owner's
Manual
SAFETY
RULES
This is the safety alert
symbol. It is used to
alert
you to potential
personal
injury
hazards.
Obey all safety messages
that follow
this symbol
to avoid possible
injury or death.
The safety alert symbol (_)
is used with a signal word
(DANGER, CAUTION,WARNING),
a pictorial and/or a
safety message to alert you to hazards. DANGER
indicates
a hazard which, if not avoided, will result in death or
serious injury. WARNING
indicates a hazard which, if not
avoided, could result in death or serious injury.
CAUTION
indicates a hazard which, if not avoided, might
result in minor or moderate
injury. CAUTION,
when
used without
the alert symbol, indicates a situation that
could result in equipment
damage. Follow safety messages
to avoid or reduce the risk of injury or death.
The manufacturer
cannot possibly anticipate every possible
circumstance
that might involve a hazard.The warnings in
this manual, and the tags and decals affixed to the unit are,
therefore,
not all-inclusive. If you use a procedure, work
method or operating technique that the manufacturer
does
not specifically recommend,
you must satisfy yourself that it
is safe for you and others.You
must also make sure that the
procedure, work method or operating technique that you
choose does not render the transfer switch unsafe.
WARNING
Only qualified electricians
should attempt
installation
of this system, which must strictly comply with
applicable codes, standards and regulations.
WARN
ING
DO NOT touch bare wires or receptacles.
DO NOT use transfer
switch with worn, frayed, bare or
otherwise
damaged wiring.
DO NOT handle electrical
cords while standing in water,
while barefoot, or while hands or feet are wet.
If you must work around a unit while it is operating, stand on
an insulated dry surface to reduce shock hazard.
DO NOT allow unqualified persons or children to operate
or
service transfer switch.
In case of an accident caused by electrical
shock, immediately
shut down the source of electrical
power and contact
the
local authorities.
Avoid
direct
contact
with
the victim.
CAUTION
Use transfer switch
only for intended uses.
If you have questions
about intended use, ask dealer or
contact
Briggs and Stratton
Power Products.
DO NOT expose transfer switch to excessive moisture,
dust,
dirt, or corrosive
vapors.
Despite the safe design of the transfer
switch, operating
this
equipment
imprudently, neglecting its maintenance
or being
careless can cause possible injury or death.
Remain alert at all times while working
on this equipment.
NEVER work on the equipment
when you are physically or
mentally fatigued.
If connected
devices overheat, turn them off and turn off their
circuit
breaker/fuse.
