Idiomas disponibles
Idiomas disponibles
6.3
LED driver mounting
LED driver mounting
retention screws
retention screws
The LED driver is fixed to the mounting bracket with two retention screws through bracket into driver base
The LED driver is fixed to the mounting bracket with two retention screws through bracket into driver base
plate. For greater flexibility the driver can be disconnected from the fixture and used remotely using Lumatek
plate. For greater flexibility the driver can be disconnected from the fixture and used remotely using Lumatek
5m LED driver extension cables (sold separately).
5m LED driver extension cables (sold separately).
To connect driver output and dimming control to fixture; ensure the power and dimming self-locking male
To connect driver output and dimming control to fixture; ensure the power and dimming self-locking male
connectors are correctly aligned with corresponding female connectors on driver and push together until
connectors are correctly aligned with corresponding female connectors on driver and push together until
click-locked. To disconnect; turn male connector anti-clockwise to unlock and pull apart from female.
click-locked. To disconnect; turn male connector anti-clockwise to unlock and pull apart from female.
6.4
Individual 100W light bars are available to purchase as replacements or with different spectral ratios to adjust
fixture spectral output.
The LED fixture's modular design uses an intelligent LED driver which can decrease or increase power to match
the amount of 100W light bars installed on the fixture automatically. If not all light bars are required, the driver
will only draw power required for the ammount of light bars connected eg if three light bars are connected
the driver will only draw 300W to power them.
. . . .
