Setting The Time Interval For Automatic; Answer; Setting Up The Voice Output Speakers; Setting The Beep Of The Incoming Call - Kenwood KCA-BT100 Manual De Instrucciones

If your control unit supports a graphic display
function:
1
Select the status display item
Push the Control knob towards [FM] or [AM].
Select the "Phone Status" display.
2
Display the statuses
Push the Control knob towards [4] or [¢].
All statuses are indicated with icons.
3
Exit Menu mode
Press the [MENU] button.
Bluetooth connection status
Display Icon
"BT-CON Y"
"BT-CON N"
Battery level of cell-phone
Display Icon
"BAT FULL"
"BAT MID"
"BAT LOW"
"BAT - - -"
Signal strength of cell-phone
Display Icon
"SGNL MAX"
"SGNL MID"
"SGNL LOW"
"NO SGNAL"
"SGNL - - -"
• Since the number of steps of the control unit is different
from that of the cell-phone, the statuses displayed on
the control unit may discord from those displayed on
the cell-phone.
Information
Connected
Disconnected
Information
Full
Nearly dead
Cannot get information.
Information
Maximum
Minimum
Outside the service range
Cannot get information.
In Standby mode
Setting the Time Interval for
Automatic Answer
This function automatically answers (responds
to) a call after lapse of the preset time interval for
automatic answer.
Display Setting
"Auto Answer: OFF"/ Does not answer the phone call automatically.
"ANS OFF"
"Auto Answer: 0s"/ Automatically answers the phone call at once.
"ANS 0"
"Auto Answer: 8s"/ Automatically answers the phone call after lapse
"ANS 8" of 8 seconds (original setting).
"Auto Answer: 99s"/ Automatically answers the phone call after lapse
"ANS 99" of 99 seconds.
• If the time set in the cell-phone is shorter than that set in
the unit, the former will be used.
In Standby mode

Setting up the Voice Output Speakers

You can specify the voice output speakers.
Display Setting
"SP Select: Front"/ Outputs voice from the front-left and front-right
"SPK FRT" speakers.
"SP Select: F-R"/ Outputs voice from the front-right speaker.
"SPK F-R"
"SP Select: F-L"/ Outputs voice from the front-left speaker.
"SPK F-L"
• Select the speaker which is further from the microphone
in order to prevent howling or echos.
In Standby mode

Setting the Beep of the Incoming Call

You can output a beep from the speaker when a call
comes in.
Display
"Call Beep: ON"/ "C-BP ON"
"Call Beep: OFF"/ "C-BP OFF" Beep is canceled.
Setting
Beep is heard.
|
English
11