Idiomas disponibles
Idiomas disponibles
CRAFTSMAN
FULL WARRANTY
If this Craftsman product fails due to a defect in material or workmanship
within two years from the date of purchase, return it to any Sears store, Parts and
Repair Service Center, or other Craftsman outlet in the United States for free repair (or replacement
if repair proves impossible).
This warranty applies for only 90 days if this product is ever used for commercial
or rental purposes.
This warranty
covers
ONLY defects
in material
and workmanship.
Sears will NOT pay for:
•
Expendable items that can wear out from normal use within the warranty period, such as cutting line, air cleaner or spark plug.
Repairs necessary because of accident or failure to operate or maintain the product according
to all supplied instructions.
Preventive maintenance,
or repairs necesary due to improper fuel mixture, contaminated
or stale fuel.
This warranty gives you specific legal rights, and you may also have other rights which vary from state to state.
Sears, Roebuck and Co., Hoffman Estates, IL 60179
APPLICATIONS
Edging along paths, driveways,
rockeries, etc.
Handme
Bairn Lock
Throttle Contol
On/Off
Control
Starter
Rope
Grip
Air Filter
Cover
Fuel
Cap
Oil Fill Plug
Muffler
Spark
Plug
Bulb
Depth
Adjustment
Lever
Edger Blade
Blade
Shield
HANDLE
ASSEMBLY
II
Middle Handle
1.
Remove the nuts and bolts
U
from the handle
components.
Be sure that
they return to the holes they
4.
came out of.
[_
Lock-Nuts
2.
Place the 2-holed end of the
_=_
:_
straight middle shaft over the
lower shaft on the unit and
align the holes (Fig. 1). Make
sure the "TO START" label is
Lower Handle
facing up.
Fig. 1
Insert the 2 flange-head
bolts
Bolt
3.
(1/4" x 1-1/4") into these holes (Fig. 1).
4.
Install the lock-nuts onto these bolts until finger tight.
5.
Using a 3/8" wrench, hold each flange-head
bolt and tighten the lock-
nuts with a 7/16" wrench until firm. DO NOT OVERTIGHTEN.
6.
Place the upper shaft of the
control handle onto the 3-holed
end of the straight middle shaft
and align the control handle's
holes with the two end-holes of
the straight metal shaft (Fig. 2).
NOTE:
The On/Off control
cables are pre-installed,
care must be taken
when installing the
control handle as to not
pinch or bend them.
This can damage the
Upper Handle_
Bolt
Fig. 2
cables and cause them to not function
properly.
7.
Insert two flange-head
bolts (1/4" x 1-1/4") into these holes (Fig. 2).
8.
Hand-start the lock-nuts
onto these bolts.
