1. Untie the end posts and pull up remaining
posts, laying each section of netting flat on
the ground.
3. Finally re-tie the bundle with the green
strings.
NORMAL RAINFALL AREAS (ALL LINES ELECTRIFIED)
To electrify all horizontal lines, connect jumper clip from power terminal of the energizer to
the built-in stainless steel power connectors. Connect ground stake to ground terminal on
energizer using the other jumper clip provided.
NORMAL RAINFALL AREAS (ALL LINES ELECTRIFIED)
To join a second roll, repeat steps 1-3 (tie the first post of the additional net to the last post
of the already installed net). Insert the post with the strings next to the last post of the first
fence and tie it together. Connect the stainless steel clips together. This is the only electrical
connection from fence to fence and automatically electrifies all lines in the net. Any post
along the line can be a corner post for directional changes.If erecting the net in a
rectangular shape, it may be necessary to add extra support posts for additional support.
When using a standard net (all wires energized), any excess can be folded back against
itself. When using a positive/ negative net, any excess should be erected but not doubled
along itself.If you are connecting the net to an existing, energized fence, be careful not to
allow the connection clips or any part of the net to contact the existing fence until - 5 -your
set up is complete. If using the nets as a stand-alone system, position the first post where
you want to enter the enclosure.
2.After the length of netting is folded up, pick
up the posts as a group and shake the net a
bit. This allows the folded pleats to
straighten themselves. Then lay netting on
the ground and roll up the folds. Start at the
end without posts and roll toward the posts.
This will produce a roll much like it began all
the posts on outside and the folds of net
rolled up inside.
8