Scrapping - Advance RS 501 Instrucciones De Uso

ENGLISH
Problem
Wheels
The rear wheels are noisy
Drive power
The machine drive power is reduced
The machine has no drive power
Drive pedal
The machine moves even if the drive pedal is
released
Cab heating
There is no hot air
The fans do not turn
Cab climate control system
There is no fresh air
NOTE
For diesel engine complete troubleshooting, see the relevant Manual.

SCRAPPING

Have the machine scrapped by a qualifi ed scrapper.
Before scrapping the machine, remove and separate the following materials, which must be disposed of properly according to the
law in force:
– Brooms
– Engine oil
– Hydraulic system oil
– Hydraulic system oil fi lters
– Plastic components
– Electrical and electronic components
NOTE
Refer to the nearest Advance Center especially when scrapping electrical and electronic components.
48
INSTRUCTIONS FOR USE
The wheel bearings are worn
The drive pedal is faulty
The by-pass is open
The drive system pump power decreases
The drive system motors are worn
The drive system pump deactivation screw for
machine pushing/towing is unscrewed
There are oil leaks from the hydraulic system
The drive system pump is broken
The drive system motor is broken
The drive pedal is misadjusted
The valve or the hot water feed hoses are broken
There are water leaks from the heater
The S26 switch is turned off/damaged
The F3.3 fuse is open
The compressor does not turn because the drive
belt is loosen/broken
There are gas leaks from the system
The expansion valve is faulty
The S27 climate control system switch is turned
off
The S26 fan switch is turned off
The engine is not running
The F3.7 fuse is open
The K12 climate control system relay is damaged
The K13 exchanger fan relay is damaged/discon-
nected
The F3.3 fuse is open
The thermostat is activated/open
There is an open in the gas pressure switch
33019745(2)2009-12
Possible cause
RS 501
Remedy
Replace
Replace
Check the by-pass screw tightening
Check the hydraulic system oil pressure on
the drive system pump
Replace
Deactivate
Repair
Replace
Replace
Adjust
Replace
Replace
Turn on
Replace
Adjust the tension/replace the belt
Repair the leak and integrate the gas
Replace
Turn on
Turn on
See the remedies for "The engine is not run-
ning" above
Replace
Replace
Replace/connect
Replace
Check the system/replace
Replace