Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Replay Mode
Press
to select the desired temperature.
Press to select the operating cycle. By pressing it repeatedly, programmed hours or a combination of programmed hours will be
selected.
To select the replay mode, press for a few seconds, time lights start to flash, replay mode is activated.
Programming time starts as soon as it is set. e.g.
The unit is set to connect and disconnect every 4 hours. If it was set at 8 a.m., the heater works as shown below.
For other configurations, e.g. offices, schools,...see full user's guide on the web.
Press once to deactivate the replay mode.
Fil Pilote
Press
to select the confort temperature.
Select the Fil pilot function. Press
for 6 few seconds; lights flash to indicate the Fil Pilot function is activated; temperature light
keeps flashing to indicate that the radiator operates according to an external signal.
2.4 BLOCK THE DEVICE.
This function enables to block the controls. To set this function, press
and simultaneously. It will take 10 minutes, after
activating the block function, to switch off the LED. To unblock, do the
same.
2.5 LED DISCONNECTED
If you do not want to have the LEDs on, use the block function. It will take 10 minutes, after activating the block function, to switch
off the LED.
3. MAINTENANCE
Keep the floor clean to avoid stains on the wall.
At the beginning of the year's heating season, the inner parts of the radiator should be vacuumed because dust can be
accumulated in the heating element while the time of the year that the radiator is been off.
The device can be washed with a moistened cloth or with any washing conventional product.
Tabla de contenido
