In case of heavy dusting, the use of a water spraying is recommended.
•
If the machine is not used for a long time, empty the water from the
•
tank.
3.4.
Cleaning and maintenance
a)
Unplug the mains plug and allow the device to cool completely before each
cleaning, adjustment or replacement of accessories, or if the device is not
being used. Wait for the rotating elements to stop.
b)
Use only non-corrosive cleaners to clean the surface.
c)
Store the unit in a dry, cool place, free from moisture and direct exposure to
sunlight.
d)
Do not spray the device with a water jet or submerge it in water.
e)
Do not allow water to get inside the device through vents in the housing of
the device.
f)
Clean the vents with a brush and compressed air.
g)
The device must be regularly inspected to check its technical efficiency and
spot any damage - check the drive belt (every 40 operating hours); the motor
carbon brushes (every 500 operating hours); the condition of the cleaning
brushes (every 1,500 operating hours).
h)
Clean the air filter regularly (every 8 operating hours) - by unscrewing it from
the dirt container and blowing it with compressed air at a not too high
pressure. If the filter is excessively dirty, replace it with a new one (~40
operating hours).
i)
Use a soft, damp cloth for cleaning.
j)
Do not use sharp and/or metal objects for cleaning (e.g. a wire brush or a
metal spatula) because they may damage the surface material of the
appliance.
k)
Do not clean the device with an acidic substance, agents of medical purposes,
thinners, fuel, oils or other chemical substances because it may damage the
device.
SAFE REMOVAL OF BATTERIES AND RECHARGEABLE BATTERIES
A 12V 100Ah battery is installed in the units (under the top cover).
Used batteries should be removed from the unit following the same procedure as
for installation:
•
The unit should be switched off and the charger disconnected.
•
Remove the cover.
Disconnect the clamps from the battery.
•
Unscrew the battery mounting bracket.
•
•
Remove the battery.
EN