WolfPack KWNG01 Manual De Instrucciones página 24

Charging the battery
• Only charge the stapler with a charger that meets the charging prameters specified by the
manufacturer. A charger that is suitable for one type of battery may present a fire risk
when used with another device.
• Check the charger and the cable plug before use. Do not use the charger if defects are
found. Do not open the charger yourself and have it repaired only by qualified personnel.
• Do not operate the charger on easily flammable surfaces (e.g. paper, textiles, etc.) or in a
combustible environment. There is a risk of fire due to overheating of the charger or
battery during charging.
• To charge the battery pack, use a power supply that meets the specifications shown in
the rating table. The USB cable must be connected to the port fig. A5. On the front of the
device, fig. A1, there is a light indicating the battery charge status.
• The red light only comes on when the battery is being charged to signal the charging
process
• Green light Battery charged
When the battery charge control indicator Fig. A1 lights up red during operation, the
battery capacity is below 30% and the battery should be recharged.
Working with a stapler
The tool has protection against unintentional operation::
• The contact switch fig. A7 ensures that the stapler is only actuated when in contact with
the surface of the material. The contact switch fig. A7 "sinks" into the stapler so that it is
flush with the underside of the stapler. Only then can the trigger be released and the staple
or nail can be driven in.
• Firmly place the stapler on the material and press the trigger Fig. A2.
• The extra pressure applied to the front of the tool will prevent recoil and increase the force
applied to the nails or staples. This is particularly important to ensure that the nail or staple
is driven through the entire material especially into a hard surface.
MAINTENANCE AND STORAGE
• Keep the machine's ventilation slots clean to prevent the engine from overheating.
• Clean the machine housing regularly with a soft cloth, preferably after each use. If the
dirt does not come off, use a soft cloth dampened with soapy water. Never use
solvents such as petrol, alcohol, ammonia water, etc. These solvents can damage
plastic parts.
• Keep it out of the reach of children, in a stable and secure position. The place should
be cool and dry, avoid too high or too low temperatures.
• Protect it from direct sunlight. Keep it in the dark if possible.
• Do not keep it in plastic bags to avoid moisture build-up.
24