Craftsman INCREDI-PULL WEEDWACKER 316.731932 Manual Del Operador página 12

This unit c anbestarted w ithanoptional Speed S tart
TM
accessory
(items sold separately). Please refer to the Speed Start
TM
accessory
operator's manual for the proper use of this feature.
Please contact your local Craftsman retailer, call 1-888-331-4569 or
visit www.craftsman.com for more information.
item No. Description
316.85951 .............................. Plug-in Power Start
316.85952 .................................. Power Bit Start
316.85953 ............................. Cordless Power Start
STARTING iNSTRUCTiONS
1. Check the oil level. Refer to Checking the Oil Level.
2. Fill the fuel tank. Refer to Fueling the Unit.
NOTE: There is no need to turn the unit on. The On/Off switch is in
the ON (I) position at all times (Fig. 8).
3. Slowly press and release the primer bulb 10 times (Fig. 9).
4. Crouch in the starting position (Fig. 10).
5. Insert the Speed Start
TM
accessory into the Speed Start
TM
port
(Fig. 11). Refer to the Operation section of the Speed Start
TM
accessory operator's manual.
6. Squeeze and hold the throttle control (Fig. 8).
7. Continue to hold the throttle control. Run the Speed Start
TM
accessory in intervals no longer than 2 seconds each until the
unit starts.
8. Remove the Speed Start
TM
accessory from the unit.
iF... the engine does not start, begin the starting procedure with step 3.
iF... the engine fails to start after 3 attempts: Squeeze and hold the
throttle control. Run the electric start accessory in intervals no
longer than 2 seconds each until the unit starts.
iF... the engine stops while the throttle control is squeezed, begin
the starting procedure with step 3.
iF THE ENGINE iS HOT... begin the starting procedure with step 3.
Fig. 11
...... _------- Speed Start
TM
Port
STOPPING iNSTRUCTiONS
1. Release the throttle control and allow the engine to idle.
2. Press and hold the On/Off switch in the OFF (O) position until
the engine comes to a complete stop (Fig. 8).
12