Idiomas disponibles
Idiomas disponibles
SUPPLIER'S DECLARATION OF CONFORMITY
Brand: BaBylissPRO
®
Model No.: FX870N
Description: Clipper
Responsible Party: Conair LLC
1 Cummings Point Road
Stamford, CT 06902
(203) 351-9000
Standards: FCC Part 15 Subpart B, ANSI C63.4-2014
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions:
(1) This device may not cause harmful interference, and (2) This device must accept
any interference received, including interference that may cause undesirable operation.
DATE OF ISSUE: 11/16/2023
FOR DIRECT PLUG-IN OPERATION OR CHARGING
Make sure clipper is off. Connect a standard charging cable into the standard charging
jack at the bottom of the clipper and plug the power adapter into a power outlet.
Note: Direct plug-in operation is only possible using the standard charging cable. The
clipper will not turn on while charging via a USB-C cable.
USB-C CHARGING INSTRUCTIONS
Make sure clipper is off. Connect a USB-C cable to the USB-C
charging port at the bottom of the clipper and plug the USB-C cable
into a certified USB power source to begin charging. Note: Clipper
will not turn on while charging via a USB-C cable.
ON/OFF SWITCH
To turn on, slide switch to the "I" position. To turn off, slide switch to the "O" position.
FX870N IB-18021A.indd 7-8
FX870N IB-18021A.indd 7-8
VERY IMPORTANT: Blades must be cleaned and oiled on a regular basis for
proper functioning. Failure to regularly clean and oil the blades will void the
warranty.
USER MAINTENANCE INSTRUCTIONS
MAINTENANCE OF THE BLADE
Always apply oil to the blades before and after use. This will ensure maximum cutting
performance and proper maintenance. Hold the clipper away from your body in a
downward position, and apply a drop of BaBylissPRO
sides of the cutter blade. Wipe off excess oil with a soft, dry cloth.
HOW TO USE COMB ATTACHMENTS
To use the comb attachments, slide the ON/OFF switch to "O" position.
Slide the comb attachment onto the top of the clipper blade and then pull
down and over the back of the blade. To remove, pull up on the back of the
comb attachment and then pull away from the blade.
REPLACEMENT (REMOVAL) OF BLADE SET
Step 1. Unplug the unit and adjust the taper lever
(see illustration A).
Step 2. Remove the screws and the fixed blade.
Save the screws.
Step 3. Lift off the small moving blade and replace
it with the new one on the plastic oscillator
(see illustration B).
Step 4. Replace the fixed blade using the screws and lightly tighten them. Adjust the
teeth, as shown in illustration C on next page, to a gap of 1/32" (0.8 mm)
to 1/16" (1.5 mm), with the small moving blade as centered and parallel as
possible to the fixed blade's teeth.
®
lubricating oil on the front and
Plastic Oscillator
Taper
B
A
Small Moving
Blade
2023/11/1 15:18
2023/11/1 15:18
