Beta 1972/20V-13BMC Manual De Instrucciones página 8

INSTRUCTIONS FOR USE ISTRUZIONI PER L'USO
- When using the drill, the operator may experience discomfort in the hands, arms, shoulders, or neck area. Adopt a comfortable
posture, avoiding unfavourable positions. Changing posture may help avoid discomfort and fatigue.
- Do not clean the drill with petrol, benzene, diluents, alcohol or the like.
Caution: if the tool is used over a protracted period of time, parts of it may become hot. Wear protective gloves.
Using the drill on the workpiece generates noise, which may prove harmful to the exposed personnel. A proper phonometric
survey is required to determine the personal hearing protective equipment (hearing protection) to use.
If a specially conducted survey suggests that the daily exposure to vibration generated from the drill exceeds the limit value
under the regulations in force in the respective country, anti-vibration gloves must be worn.
- If you notice that the skin of your fingers becomes numb, tingles or hurts, stop working with the drill, inform your employer and
seek medical advice.
- Hold the drill securely, though not too firmly, according to the required reaction force of the hand.
PERSONAL PROTECTIVE EQUIPMENT TO WEAR WHILE OPERATING BATTERY DRILL
Failure to observe trhe following warnings may result in physical injury and/or disease
ALWAYS WEAR HEARING PROTECTION WHILE OPERATING TOOL
ALWAYS WEAR EYE PROTECTION WHILE OPERATING TOOL OR PERFORMING
MAINTENANCE JOBS
ALWAYS WEAR PROTECTIVE GLOVES AGAINST PHYSICAL AGENTS WHILE
OPERATING TOOL
ALWAYS WEAR SAFETY SHOES.
Additional personal protective equipment to wear according to the values found in the environmental
hygiene/risk analysis survey if the values exceed the limits under current regulations.
BATTERY DRILL USE AND CARE
- Do not overload the drill. Use the drill only as intended.
- Do not use if the switch does not work properly. If the tool cannot be controlled by means of the switch, it is dangerous and must
be repaired.
- Always check that the tool is free from defects. Do not use a drill that has a defective on/off switch. A drill that can no longer be
stopped or started is dangerous and must be repaired.
- Make any adjustments when the drill is off. When the drill is not used, disconnect the battery. This safety measure prevents
accidental starting of the drill.
- Have the drill repaired only through trained personnel. Only use original replacement parts. For such jobs, you can contact Beta
Utensili S.p.A.'s repair centre.
- The start button must not be locked with adhesive tape or clamps.
Use clamping devices or a vice to secure and support the workpiece. Holding the workpiece by hand or against
your body will not allow for safe operation of the drill.
8
EN I