OPERATION
Lifting
1. Install the handle assemble well according to assembly drawing.
2. Turn the handwheel clockwise until snug.
3. Adjust the handle angle degree as needed place the jack into position under the load.
Caution: Follow all Safety and Precautions.
4. Adjust the extension screw as needed. Turn counter-clockwise to raise and clockwise to lower.
5. Connect the air supply hose lock fitting into the air inter fitting. The lever should be off (not in the
locked position).
6. Press the lever to the on position and lock using the lock lever. This provides a continuous air
supply to the air motor.
7. Raise the jack by alternately lifting and lowering the handle assembly.
Lowering
Caution: Avoid rapid descent of the load. Turn the release valve slowly.
1. Release the lock level to slop air flow to the air motor.
2. Remove air supply hose from the air inlet fitting.
3. Slowly and carefully lower the load by turning the handwheel counterclockwise in extremely small
increments using only the handle assembly (never your hand).
4. Lower the extension screw as needed by turning clockwise.
5. Remove the jack.
MAINTENANCE
General Care
1. Periodically lubricate the joints and Extension Screw with a light oil as needed.
2. Clean the outside of the jack with a dry clean cloth.
3. If the jack is exposed to moisture, wipe dry with a clean cloth and lubricate as noled above.
4. Store Jack with Extension Screw and Ram fully collapsed.
Purging Air from the hydraulic system
Purging air from the hydraulic system. Air bubbles can become trapped inside the hydraulic system
thereby reducing the efficiency of the Jack. Purge the air from the system if lift efficiency drops.
1. Turn the handwheel counterclockwise.
2. Remove the oil filler plug on the side of the jack reservoir by gently pulling.
3. Connect the air supply hose into the air inlet fitting. Open the air valve and work for a moment to
purge the air from the hydraulic system.
4. Turn the hand wheel clockwise until snug.
5. Too off jack reservoir as described below. Replace the filler plug
Oil replacement
1. Place jack in an upright position.
2. Completely lower the ram.
3. Remove the filter plug.
4. Fill with High-Quality hydraulic jack oil to the lower rim of the fill hole.
5. Purge air from the hydraulic system as previously described.
6. Top off with more hydraulic oil. Replace filler plug.
PLEASE READ THE FOLLOWING CAREFULLY
The manufacturer and distributor has provided the parts diagram in this manual as a reference tool
only neither the manufacturer now distributor makes any representation or warranty that the buyer is
qualified to make any repairs to the product. The manufacturer and distributor expressly states, that
all repairs should be undertaken by certified and licensed technicians. Buyer assumes all risks and
liability, that resulting from its own repair of the tool.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Tel.: 02196 720480
Fax.: 02196 7204820
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed
