Idiomas disponibles
Idiomas disponibles
If the blade stalls, immediately stop the trimmer.
Release the Operator Presence Switch and
Throttle Trigger before attempting to clear jammed
debris from the cutting blades.
Wear gloves when trimming thorny or prickly
growth.
Do not attempt to cut stems that are too thick for
the cutting blade.
Top cutting
Use a wide sweeping motion. A slight downward tilt
of the cutting blades in the direction of motion gives
the best cutting results.
Side cutting
When trimming the sides of the hedge, begin at the
bottom and cut upwards, tapering the hedge inward
at the top. This shape will expose more of the
hedge, resulting in a more uniformed growth
BATTERY STATUS (See Fig. G )
•
Before starting or after use, press the button
beside the power indicator light on the machine
to check the battery capacity.
•
During operation, the battery capacity will be
indicated automatically by the battery power
indicator. The indicator constantly senses and
displays the battery condition as follows.
•
For the machine with 2 battery packs with
different power, the power indicator light
displays the battery condition with the lower one
of the two batteries.
14
Battery indicator light
status
Five green lights
(
) are
illuminated.
Two, three or four
green lights are
illuminated.
Only one green
light (
) is
illuminated.
No light is illuminated.
Only one light is
flashing twice per
cycle.
40V Cordless Hedge Trimmer EN
Battery condition
The two batteries are in a
highly charged condition.
The two batteries have a
remaining charge. The more
lights are illuminated, the
more battery capacity.
At least one battery is almost
depleted and needs to be
charged.
At least one battery is not
fully installed or battery may
be defective.
At least one battery is over
discharged (please refer to
the battery charge condition),
please recharge the two
batteries at once before use
again or storage.
Only one light is
flashing three times
per cycle.
Only one light is
flashing four times per
cycle.
7. MAINTENANCE
Remove the battery from Hedge trimmer before
carrying out any adjustment, servicing or
maintenance.
There are no user serviceable parts in your power
tool. Never use water or chemical cleaners to clean
your power tool. Wipe clean with a dry cloth. Always
store your power tool in a dry place. Keep the motor
ventilation slots clean. Keep all working controls
free of dust.
8. ENVIRONMENTAL
PROTECTION
Waste electrical products should not be
disposed of with household waste. Please
recycle where facilities exist. Check with your
Local Authority or retailer for recycling advice.
FOR BATTERY TOOLS
The ambient temperature range for the use and
storage of tool and battery is 0°C-45°C.
The recommended ambient temperature range for
the charging system during charging is 0°C-40°C.
At least one battery is hot,
wait for them cool down
before start again.
The machine is over load.
Remove tool from cutting
area and try again.
