Idiomas disponibles
Idiomas disponibles
Charging the battery pack
NOTE :
•
The batteries are shipped
uncharged. Each battery must be
fully charged before the first use.
•
Always fully charge the two
batteries at same time. More
details can be found in charger's
manual.
Installing and Removing the battery
pack
NOTE :
•
This machine will only run when
2 batteries are installed. It is
recommended to use the same
two batteries and charge the two
batteries at the same time.
•
When you use two batteries
with different power, the
machine will only run to the
lower common denominator.
ower indicator light
P
See details in BATTERY STATUS part
IMPORTANT:
When only one light is illuminated,
your battery is overly discharged,
even though the trimmer may still
be capable of hedge trimming.
Continuing to operate your trimmer
with the battery in this discharged
condition may reduce the life and
performance of your battery.
When no light is illuminated, at least
one battery is not fully installed or
battery may be defective, please
double check the batteries are fully
seated into position.
OPERATION
Remove the blade sheath
Starting and stopping
40V Cordless Hedge Trimmer EN
Rotating rear handle
NOTE :
• Unlock the locking switch before
rotating.
See Fig. E
• After rotating the handle to the
desired position, adjust it a little
until a click can be heard.
WARNING:
• Always make sure that the handle
is locked in the desired position
before operation.
• Always make sure the locking
switch is locked before starting
the hedge trimmer.
See Fig. F
Top cutting
WARNING: If any parts are
missing, damaged or broken,
do not operate your hedge trimmer
until all damaged parts have been
replaced or repaired. Failure to do
so could result in serious personal
injury. DO NOT USE WITHOUT FRONT
HANDLE AND SAFETY GUARD.
Side cutting
WARNING: Stop operating the trim-
mer before rotating the handle.
Lubricating the Cutting Blade
See Fig. G
Remove the battery pack from the
trimmer.
Place the trimmer on a level surface.
Apply some lubrication oil along the
edge of the blade.
It is recommended to oil the machine
after using your hedge trimmer for an
extended period.
WARNING: Do not oil the blade when
the trimmer is running.
See Fig. H
6. HOW TO USE YOUR HEDGE
See Fig.
I1, I2
TRIMMER
Before cutting an area, inspect it first and remove
any foreign objects that could become thrown or
entangled in the blades. Always hold the trimmer
with both hands and with the blade away from you
before turning it on.
When trimming new growth, use a wide sweeping
action so that the stems are fed directly into the
blade.
Allow the cutting blades to reach full speed before
cutting. When operating, keep the cutting blades
away from people and objects such as walls, large
stones, trees, vehicles, etc.
See Fig.
J1, J2
See Fig. K
See Fig.
L1, L2
13
See Fig. M
