Nomenclature; Monitor; Outside Station; Electronic Control Box - Extel MINI Instrucciones De Uso

3. NOMENCLATURE

a. Monitor
(fig. 2)
1. LED indicator / orange: charging / flashing green: un-read messages / green: battery 100% charged on the mains
2 Button to answer a call
3. Button to open an electric latch
4. Gate opening button
5. Validation button and directional keys
6. Monitor On/Off button
7. Micro SD card reader (32 Gb max possible)
8. Socket for the 5 V adapter plug (adapter to connect to an installation compliant with applicable standards: BS
7671 in the UK)
9. Silent mode (no chimes)
10. Micro SD card reading
11. Settings
12. Reset.
b. Outside station
(fig. 3)
1. IR Led: night vision (light invisible to the naked eye) with dusk sensor.
2. C-MOS camera lens
3. Speaker
4. Call button - only luminous with external power supply
5. Name holder and light indicator:
- if the electronic control box is battery powered, the indicator will not light.
- if the electronic control box is powered using low voltage (12 or 24 V AC/DC), the name holder lights automat-
ically in the dark.
- gently lift the plastic protection using a small screw driver, place the name holder label and refit the plastic protector
6. Microphone
7. Fixture screws to mount the station on the shield
8. Terminal block to connect the wires
9. Wiring label
c. Electronic control box
(fig. 4)
1. Aerial
2. SMA aerial connector
3. Wire cable to connect the control box to the outside station
4. Battery compartment
5. Terminal block to connect an automated portal
6. Terminal block to connect the electric door opener or electric lock
7. Power supply terminal block (12 or 24 V AC/DC)
8. Pairing and reset buttons
9. Indicator LED
CFI EXTEL MINI - 10/2016
GB3