Idiomas disponibles
Idiomas disponibles
_tting
Und_rc_in_g
Undercutting
involves cutting on the
underside of the log with top of saw
against the log. When undercutting
use light upward pressure. Hold saw
firmly and maintain control. The saw
will tend to push back toward you.
WARNING:
Never tum saw up-
side down to undercut. The saw can-
not be controlled in this position.
Always make your first cut on the com-
pression side of the log. The compres-
sion side of the log is where the pres-
sure of the log's weight is
concentrated.
First cut on compression side of log
j
Second cut
First cut on compression side of log
BUCKING
WITHOUT
A SUPPORT
• Overcut through 1/3 of the diameter
of the log.
• Roll the log over and finish with a
second overcut.
• Watch for logs with a compression
side to prevent the saw from pinch-
ing.
See illustration above for cut-
ting logs with a compression side.
BUCKING
USING A LOG OR
SUPPORT
STAND
• Remember
your first cut is always on
the compression side of the log. (Re-
fer to the iUustrations below for your
first and second cut).
• Your first cut should extend 1/3 of the
diameter of the log.
• Finish with your second cut.
Using a log for support
I st Cut
2nd
Using a support
stand
"2nd Cut
(_i
_st Cut
1StCut ._.
LIMBING
AND PRUNING
_WARNING:
Be alert for and guard
against kickback. Do not allow the mov-
ing chain to contact any other branches
or objects at the nose of the guide bar
when limbing or pruning. Allowing such
contact can result in sedous injury.
_WARNING:
Never climb into a
tree to limb or prune. Do not stand on
ladders, platforms, a log, or in any po-
sition which can cause you to lose
your balance or control of the saw.
IMPORTANT
POINTS
• Watch out for springpoles.
Spdngpoles
are small size limbs
which can whip toward you, or pull
you off balance. Use extreme cau-
tion when cutting small size limbs.
• Be alert for spdngback from any
branches that are bent or under
pressure. Avoid being struck by the
branch or the saw when the tension
in the wood fibers' is released.
• Frequently clear branches out of the
way to avoid tdpplng over them.
LIMBING
• Limb a tree only after it is cut down.
• Leave the larger limbs underneath
the felled tree to support the tree as
you work.
• Start at the base of the felled tree
and work toward the top, cutting
branches and limbs. Remove small
limbs with one cut.
12
