Idiomas disponibles
Idiomas disponibles
EN
INSTRUCTION MANUAL
IMPORTANT INFORMATION! You must charge completely before first use, after every jump start
and every 30 days
PRODUCT'S PRESENTATION
The jump starter is designed to start cars, boats and
other vehicles when the vehicle's battery cannot be
used, avoiding you the need to seek assistance from
other drivers. It is equipped with 12V power source, a
LED light which can be used in emergency situations,
and LED lights that indicates the battery's inter-
nal status. This jump starter can be used to provide
power to 12V DC appliances by means of its 12V DC
outlet socket and can be charged with an external
charger by connecting it to the charging socket. It
also has an automatic current overload protection
for the battery.
SAFETY INSTRUCTRIONS
WARNING! Read all safety warnings and all ins-
tructions. Failure to follow the warnings and instruc-
tions listed below may result in electric shock, fire
and/or serious injury.
• Keep the working area clean and well lit.
• Keep children and non-authorized personnel
away from the working area.
• Do not operate the angle grinder if you get tired
easily or under the influence of drugs, alcohol or
medication.
• Dress properly. Do not wear loose clothing or
jewelry and contain long hair.
• Always wear eye and respiratory protection.
• Do not operate the tool in the presence of flam-
mable liquid or gases.
• Do not expose the unit to rain or wet conditions.
• Make sure the switch (black rotatory knob) is in
the off position while not in use. It will prevent
any damaged caused by an accidental con-
nection between red and black clamps.
• Do not connect red and black clamps directly or
to the same conductor at the same time.
• Before use, make sure the car battery and jump
starter selected voltage matches, and clamps
are connected to the correct polarities.
NOTE! Do not use the jump starter as a car battery
replacement and the vehicle power supply.
• Do not pull or carry the unit by its cables, and do
not pull the clamps from the battery terminals.
• Do not store the tool in wet locations or places
where temperature may exceed 50 C.
• Have water and soap nearby in case battery
acid comes in contact with skin, clothing or eyes,
and wash immediately if so.
IMPORTANT REMARKS
1. The warning light (7) changes the color in diffe-
rent speed as a warning for the operator:
• If the clamps are correctly connected to the
battery terminals, the light is green.
• If the clamps are connected to the battery ter-
minals incorrectly, the light will flicker in red two
times per second, and an alarm will sound.
2. If the internal battery voltage is low, the char-
ging status light (3) will flicker in red.
OPERATION
Charging the jump starter
NOTE! Check the internal power status by pressing
the power testing button (9) and checking the vol-
tage meter (8) before the first use. If the red charging
status light is on, charge the unit as soon as possible.
1. Connect the charger to the power supply.
2. Connect the charger plug into the charging soc-
ket (11).
3. The LED light (3) will turn on once the jump star-
ter is being charged.
4. Once the jump starter is fully charged, the LED
light (4) will be on.
5. Remove the charger from the socket and dis-
connect the charger from the power supply.
12V DC output socket
You can use the jump starter to charge 12V DC
appliances:
1. Remove the cover of the 12V output socket.
2. Insert the 12V cigarette lighter socket adaptor
· 4 ·
REF. 53687
