Idiomas disponibles
Idiomas disponibles
Gigaset SL44 / IM1 engl / A31008-M1609-R101-1-6Z19 / start_guide_time.fm / 20.08.2004
Appendix
Appendix
Care
¤
Wipe the charging cradle and the hand-
set with a damp cloth (do not use sol-
vent) or an antistatic cloth.
Never use a dry cloth. This can cause
static.
Contact with liquid
¤
Switch the handset off immediately if it
comes into contact with liquid.
¤
Do not switch the handset on under
any circumstances.
¤
Remove the batteries immediately.
Allow the liquid to drain from the handset.
Proceed only as follows:
¤
Hold the handset horizontally with the
open battery compartment facing
down.
¤
Hold the handset vertically and tilt it
slightly backwards and forwards, shak-
ing it gently.
¤
Pat all parts dry, then place the handset
with the battery compartment open
and the keypad facing down in a dry,
warm place for at least 72 hours (not
in a microwave, oven etc.).
When it is completely dry you will nor-
mally be able to use it again.
24
Questions and answers
If you have any queries about the use of
your phone, you can contact us at any
time at www.siemens-mobile.com/gigas-
etcustomercare. The table below contains
a list of common problems and possible
solutions.
The display is blank.
1. The handset is not switched on.
!
2. The batteries are flat.
The handset does not respond to a key press.
The keypad lock is activated.
¥
"Basis x" flashes in the display.
1. The handset is outside the range of the
2. The handset has been de-registered.
Base Search flashes in the display.
The handset is set for
within range.
¥
Handset does not ring.
The ringer is switched off.
¥
The other party cannot hear you.
You have pressed the
set is "muted".
¥
You hear an error tone when keying an input
(a descending sequence of tones).
Action has failed/invalid input.
¥
¥
Press the 'end call' key
¥
Charge or replace the batteries (page 4,
page 5).
Press and hold the hash key
(page 6).
base.
¥
Move the handset closer to the base.
¥
Register the handset (page 4).
Best Base
Move the handset closer to the base.
Activate the ringer (page 19).
u
(INT) key. The hand-
Switch on the microphone again (page 11).
Repeat the operation.
Watch the display and refer to the user-
guide if necessary.
a
and hold.
#
and no base is
