Idiomas disponibles
Idiomas disponibles
Choosing Cooling or Heating mode :
look for JUMPER select or on PCB shown in picture (at top left corner on the back of the Front part)
A. Cooling mode chosen - this thermostat will work as Room thermostat for cooling only.
Display on LCD will be: system on
Functions provided in thermostat that involve floor-heating will be disabled when Cooling mode is chosen. Do not choose Cooling-
mode if you are using this thermostat for floor-heating.
Symbol of
will appear on LCD to alert users, if an error occurred in this selection.
B. Heating mode chosen - for use of this thermostat for Heating or Floor-Heating.
Display on LCD will be: heating on
To enable or disable the room sensor
This selection provides 3 operating modes:
A. Room mode - Room sensor controls on/off
Display on LCD shall show room-mode symbol
Room Sensor must be enabled, floor sensor is not connected
B. Floor mode (Floor heating) — Floor sensor controls on/off
Display on LCD shall show.
Room sensor must be disabled, floor sensor is connected
C. Room + Floor limitation (Floor heating)
Room sensor controls on/off with Floor sensor controls floor temperature limitation. Display on LCD shall show
Room Sensor must be enabled, floor sensor is connected
Locate for JUMPER selector on PCB shown in picture. Choose "enabled" or" disabled".
Locate for JUMPER selector on PCB shown in picture. Choose "enabled" or" disabled".
Enabled.
Room Sensor
enabled.
To close the unit: Line up the pins with the connector
1. Put the
frame be
situated on top
of the bottom
part.
3. Close
another side
Email: [email protected]
system off
heating off
(Room sensor is positioned inside the thermostat)
Disabled.
Room Sensor
disabled.
2. Placing
one side of the
top part in the
frame.
4. Press the
front part
downward to
firmly close
Be certain the two hook-on
clips extends from the bottom
part are positioned in the
spuare holes on the front part.
Remark: This unit has
compatible plastic
housing structure to most
commercially available
recessed conduit boxes. Users
can insert the bottom part in
the conduit box and directly
close the front part on top
of the bottom part without
the frame being situated in
middle.
EN
9
