Idiomas disponibles
Idiomas disponibles
13
TROUBLESHOOTING
Problem
The machine does not
start when you push the
trigger.
The machine stops
when you cut.
The line does not ad-
vance.
The line keeps break-
ing.
The grass winds around
the trimmer head and
motor housing.
English
Possible Cause
No electrical contact between the
machine and the battery pack.
The battery pack is depleted.
The lock-out button and trigger are
not pushed at the same time.
The guard is not attached to the ma-
chine.
Heavy cutting line is used.
The grass winds around the motor
shaft or the trimmer head.
The motor is overloaded.
The battery pack or machine is too
hot.
The battery pack is disconnected
from the tool.
The battery pack is depleted.
Not enough line on spool.
Lines are worn too short.
Lines are tangled on spool.
The machine is used incorrectly.
Cut tall grass at ground level.
Solution
1. Remove battery pack.
2. Check contact and install the battery pack
again.
Charge the battery pack.
1. Push the lock-out button and hold it.
2. Pull the trigger to start the machine.
Remove the battery pack and attach the guard to
the machine.
Use only with the nylon cutting line of 0.095" (2.4
mm) diameter.
1. Stop the machine.
2. Remove the battery pack.
3. Remove the grass from the motor shaft and
trimmer head.
1. Remove the trimmer head from the grass.
2. The motor will recover to work as soon as the
load is removed.
3. When you cut, move the trimmer head in and
out of the grass to be cut and remove no more
than 8" in pass.
1. Cool the battery pack until its function returns to
normal.
2. Cool the machine for approximately 10 minutes.
Install the battery pack again.
Charge the battery pack.
Install more line.
Advance the cutting line.
1. Remove the lines from the spool.
2. Wind the lines.
1. Cut with the tip of the line, avoid stones, walls
and other hard objects.
2. Advance the cutting line regularly to keep full
cutting width.
1. Cut tall grass from the top down.
2. Remove no more than 8" in each pass to pre-
vent wrapping.
13
EN
