Idiomas disponibles
Idiomas disponibles
EN
9.7
ADJUST THE LENGTH OF THE
CUTTING LINE
While you operate the machine, the cutting line gets
worn and shorter. You can adjust the length of the
cutting line.
1. Hit the trimmer head against the ground while you
operate the machine.
2. Line is automatically released and the cut-off blade
cuts the excess length.
10
MAINTENANCE
Read and understand the safety regulations and the
maintenance instructions before you clean, repair or
do the maintenance work on the machine.
Make sure that all nuts, bolts and screws are tight.
Examine regularly that you install the handles tightly.
Use only the replacement parts and accessories of the
initial manufacturer.
10.1 GENERAL INFORMATION
Only your dealer or approved service center can do
the maintenance that is not given in this manual.
Before the maintenance operations:
•
Stop the machine.
•
Remove the battery pack.
•
Cool the motor.
•
Store the machine in cool and dry place.
•
Use correct clothing, protective gloves and safety
glasses.
IMPORTANT
IMPORTANT
IMPORTANT
IMPORTANT
English
10.2 CLEAN THE MACHINE
•
Clean the machine after use with a moist cloth
dipped in neutral detergent.
•
Do not use aggressive detergents or solvents to
clean the plastic parts or handles.
•
Keep the trimmer head free of grass, leaves, or
excessive grease.
•
Keep the air vents clean and free of debris to avoid
overheating and damage to the motor or the battery.
•
Do not spray water onto the motor and electrical
components.
10.3 INSTALL THE CUTTING LINE
Do not put more than 15 feet of cutting line in at a
time.
1. Remove the remaining cutting line on the spool.
2. Line up the slots on the spool cap with the slots on
the trimmer head.
3. Put the cutting line through the hole. Push the
cutting line until it exits the opposite hole.
4. Pull the cutting line through until there is an equal
quantity of cutting line on each side.
10
NOTE
