Idiomas disponibles
Idiomas disponibles
Cleaning
of Humidifier
(continued)
Step 3
Removing
Scale
1. Fill the humidifier base with one 8 oz.
cup of undiluted white vinegar. Let
solution stay 20 minutes,
2. Clean all interior surfaces with a soft
brush. Dampen a soft cloth with undi-
luted white vinegar and wipe out the
base to remove scale,
3. Rinse thoroughly with clean warm
water to remove scale and cleaning
solution.
Disinfecting
Base
1. Pour 1 gallon of water and 1 teaspoon
chlorine bleach into the base. Let
solution stay for 20 minutes, carefully
swishing every few minutes. Wet all
surfaces normally exposed to wateE
2. Empty base after 20 minutes. Rinse
with water until bleach smell is gone.
Allow unit to db/out
completely.
NOTE: The water bottle should be
cleaned in the same manner as the base.
Rinse thoroughly with clean water after
all steps are complete.
End
of Season
Maintenance
1. Follow "Bi-Weekly Maintenance"
instructions
at end of humidification
season.
2. Remove filter and dispose of properly.
3. Let humidifier dry completely before
storing, Do not store with water inside
base or bottle,
4. Store in cool, dry location.
5. Install a new filter in clean humidifier
before next season begins.
Note: "Bi-Weekly Maintenance"
is
also recommended
if you do not plan
to run the humidifier for one week or
more.
Position
start
and
finish of coiled
fluter
er of base.
Step 4
Replacing
Parts
1. InstalI a new filter (42-14906) or the
filter previously set aside if it is in
good condition into the base, Coil the
filter and position it between the
uprights in the bottom of the base,
The start and finish of the coil should
be captured in the centre of the base
(see diagram) and the filter should be
resting on the floor of the base.
2. Return the housing assembly to the
top of the base, Return the water bot-
tle to the right of the housing assem-
bly and reposition the humidifier to its
operating position,
3. The humidifier is now ready to be
filled for operation.
top
of base
and
reposition
secureUy,
15
