Idiomas disponibles
Idiomas disponibles
Fault
Error message
E02 or E03
shows in the
display.
8 Technical data
Model:
Voltage:
Power:
Motor speed:
Max. air speed:
Noise level:
Weight:
9 FCC statement
This device complies with Part 15 of the FCC Rules. Operation
is subject to the following two conditions: (1) this device may
not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause
undesired operation.
Warning: Changes or modifications to this unit not expressly
approved by the party responsible for compliance could void the
user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio
communications.
However, there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is
Possible cause and solution
• The voltage is either too low or high.
Connect the product to an appropriate
power outlet.
HCA01NA
125 V~, 50/60 Hz
1,600 W
110,000 rpm
47.2 mile/hr (76 km/hr)
≤ 75.7 dB (11.8 inches/30 cm)
24.5 oz (695 g)
EN
14
