Idiomas disponibles
Idiomas disponibles
6.
Check door alignment with cabinet. If door hits cabinet, reposition or
level the dishwasher. See "Level the Dishwasher."
7.
Verify that the water supply and drain lines are not kinked or in contact
with other components.
8.
Turn on the sink hot water faucet and verify water temperature.
Incoming water temperature must be between 120°F and 150°F (49°C
and 65°C). A minimum of 120°F (49°C) temperature is required for best
wash performance.
9.
Add 2 quarts (1.9 L) of water to the bottom of the dishwasher to
lubricate the pump seal.
10.
Turn on water supply. Check for leaks. Tighten connections if needed.
11.
Remove protective film, if present, from the control panel and do .
TEST DISHWASHER
WARNING
Electrical Shock Hazard
•
•
If connecting with a power cord:
•
•
•
•
•
•
If using a direct wire cable, turn on power at source.
•
If using a power cord, plug cord into a grounded 3-prong outlet.
Make sure the power cord does not touch the motor or the lower
part of the dishwasher tub, and then turn on power at source.
1.
Connect to power supply.
On the Control Panel, press the controls needed to start the shortest
2.
cycle. See the User Manual for instructions.
Firmly close the dishwasher door within 4 seconds of pressing START.
3.
After the fir t 2 minutes, open the door. Check to see that there is
4.
water in the bottom of the dishwasher tub. If water has not entered the
dishwasher, check that the water and power supplies are turned on.
Electrically ground dishwasher.
Connect ground wire to green ground connector in
terminal box.
Plug into a grounded 3-prong outlet.
Do not use an adapter.
Do not remove the ground prong from the power cord
plug.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fi e, or electrical shock.
33
