Idiomas disponibles
Idiomas disponibles
Nozzle
• A fine jet has a high impact force on the surface
being cleaned and maximum deep cleaning re-
sults are concentrated in this area. However, the
high impact of the concentrated jet must be used
with caution as it can damage some surfaces.
• A wide jet distributes the impact of the water over
a larger area resulting in an excellent cleaning ac-
tion with a reduced risk of damage to the surface.
Large surfaces can be cleaned more quickly using
a wider jet model.
ANGLE OF CLEANING OF A SURFACE
When a surface is sprayed with water, the maximum
impact is generated when the water hits the surface
"head-on". However, this impact tends to embed dirt
particles in the surface, thus preventing the desired
cleaning action. The optimal angle of the water spray to
clean a surface is 45 degrees. Spraying water against
a surface at this angle produces the most effective im-
pact that removes the remaining dirt from the surface.
DISTANCE FROM THE CLEANING SURFACE
Another factor that determines the strength of the wa-
ter impact is the distance between the nozzle and the
surface being cleaned. The force of the water's impact
increases as the nozzle approaches the surface.
The force of the impact can be regulated in several
ways. Never use a high impact fine spray or turbo/rota-
ting nozzle on a surface that is susceptible to damage.
Avoid spraying windows with a high-impact fine spray
or turbo nozzle because they may break.
The safest way to avoid surface damage is to follow
these steps:
1. Before pulling the trigger, adjust the nozzle so that
a wide spray pattern is produced.
2. Place the nozzle approximately 4-5 feet (1.2-
1.4m) and at a 45-degree angle to the surface to
be cleaned and pull the trigger.
3. Change the spray angle and distance from the cle-
aning surface until maximum efficiency is achie-
ved without damaging the surface.
TURBO NOZZLE
The turbo nozzle combines the power of a high-impact
fine jet and the efficiency of a 25-degree angle jet. This
swirls the high-impact fine jet into a cone shape provi-
ding cleaning of a larger area.
CAUTION: Since the turbo nozzle uses a high-impact
fine spray, use it only to clean surfaces that will not be
damaged by this type of high-impact spray. Also, the
turbo nozzle is NOT adjustable and cannot be used to
apply detergent.
WATER INLET FILTER
The water inlet filter should be inspected regularly to
avoid blockages and restrictions between the water
inlet and the pump.
DETERGENT APPLICATION
To apply the detergent, follow the following steps:
1.
Pour detergent into the soap bottle.
2.
Rotate the knob on the top of the kettle as
shown in the picture to adjust the size of the
sprayed foam.
3.
Rotate the front end of the kettle as shown to
adjust the angle of foaming.
· 8 ·
REF. 53948
