Idiomas disponibles
Idiomas disponibles
The operation
of any tiller can result in foreign
objects
thrown
into the eyes,
which
can result in severe
eye damage.
Always
wear safety glasses
or eye
shields
before
starting
your tiller and while tilling.
We recommend
standard
safety glasses
or a wide vision safety
mask worn
over spectacles.
HOW TO USE YOUR TILLER
Know how to operate
all controls
before
adding
fuel and oil or attempting
to start
engine.
STOPPING
TINES
• Release
tine control
to stop movement.
ENGINE
• Move throttle
control
to "STOP"
position.
NOTE:
Never use choke to stop engine.
Tine Control
"Off" (UP) Position
WHEELS
Adjust wheels
by removing
the hairpin
clip
and clevis
pin.
Change
wheel
position.
Replace
the hairpin
clip and clevis
pin.
• For normal
tilling, set wheels
at the
second
or third hole from the top.
Hairpin Clip and
Clevis Pin
Tine Control
"On" (DOWN) Position
Choke
Control
Control
TINE OPERATION
• Squeeze tine control to handle.
TILLING
The speed
and depth of tilling
is regulated
by the position
of the depth
stake
and
wheel
height.
The depth
stake should
always
be below
the wheels
for digging.
It serves
as a
brake to slow the tiller's forward
motion
to
enable
the tines to penetrate
the ground.
Also, the more the depth
stake
is lowered
into the ground
the deeper
the tines will
dig.
DEPTH
STAKE
Adjust
depth
stake by removing
the hairpin
clip and clevis pin.
Change
depth
stake
to desired
position.
Replace
the clevis pin
and hairpin
clip.
• For normal
tilling, set depth stake
at the
second
or third hole from the top.
Depth
Stake
Wheel
Spring
TO TRANSPORT
,_CAUTION:
Before
lifting or transporting,
allow tiller engine
and muffler
to cool.
Dis-
connect
spark plug wire.
Drain gasoline
from fuel tank.
AROUND
THEYARD
1. Tip depth
stake forward
until it is held
by the stake spring.
2.
Push tiller handles
down,
raising
tines
off the ground.
3.
Push or pull tiller to desired
location.
AROUND
TOWN
1.
Disconnect
spark
plug wire.
2.
Drain fuel tank.
3.
Transport
in upright
position
to prevent
oil leakage.
BEFORE
STARTING
ENGINE
IMPORTANT:
Be very careful
not to allow
dirt to enter the engine
when
checking
or
adding
oil or fuel.
Use clean oil and fuel
and store in approved,
clean,
covered
containers,
use clean fill funnels.
FILL
ENGINEWlTH
OIL
1.
Remove
hangtag
from engine.
2.
With engine
level, remove
engine
oil
filler plug.
3.
Fill engine
with oil to point of over-
flowing.
For approximate
capacity
see
"PRODUCT
SPECIFICATIONS"
on
page 4 of this manual.
All oil must meet
A.P.I. Service
Classification
SG-SL
