Idiomas disponibles
Idiomas disponibles
12 Disassembly
12 Disassembly
13 Disposal
13.1 Materials
EN - 24
DANGER
Risk of injury due to unexpected start-up
The following instructions must be adhered to throughout all maintenance,
servicing, assembly, disassembly and repair work:
• Switch off the power source.
• Close the gas supply.
• Disconnect the mains plug.
• Switch off the entire welding system.
NOTICE
• Disassembly may only be carried out by qualified personnel (in Germany
see TRBS 1203).
• Please consult the operating instructions for the welding components,
such as the power source, wire feeder, coolant recirculator, etc.
• Observe the information provided in the following section:
9 Putting out of operation on page EN-19.
1 Detach the welding torch from the power source.
2 Remove all wear parts.
When disposing of the system, local regulations, laws, provisions, standards
and guidelines must be observed. Observe the regulations on the disposal of
electronic scrap and dispose of it at your local waste disposal site (e.g.
recycling centre).
To correctly dispose of the product, it must first be disassembled. Please take
note of the following information:
12 Disassembly on page EN-24
This product is mainly made of metallic materials, which can be melted in steel
and iron works and are thus almost infinitely recyclable. The plastic materials
used are labelled in preparation for their sorting and separation for later
recycling.
MIG/MAG welding torches ML/MW GRIP
