Idiomas disponibles
Idiomas disponibles
Before performing cleaning, adjusting, repairing and
maintenance tasks, the power cord must be
unplugged.
Replace worn out or damaged parts immediately, so that
the air compressor is always in a safe operating condition.
Cleaning:
The compressor must be thoroughly cleaned after each
use.
Do not use aggressive cleaning products. These products
may damage plastics and metals, compromising the safe
operation of the air compressor.
Maintenance:
Only maintenance works described in this instruction
manual may be carried out, all other works must be
performed by an official dealer.
Keep all nuts and bolts firmly tightened.
If you remove components or safety devices to carry out
maintenance work, they must be replaced and repositioned
immediately and correctly.
Use only VITO-approved attachable accessories for this
machine or technically identical parts. Failure to do so may
result in personal injuries or damages to the air
compressor. If in doubt, if you lack knowledge or resources,
you should contact an official dealer
The air compressor should only be serviced by the brand's
technical assistance center, or other qualified personnel,
replacing any necessary parts with original parts.
T
he compressor must be assembled with the wheels and
placed on a horizontal and firm surface, which can bear its
weight and vibrations during operation. Never use the
compressor in a surface with a slope of more than 15°.
If the compressor is installed in a permanently fixed
surface, it is recommended to place dampers between the
air tank support base and the ground. The air tank's
support base must not be fixed directly on the ground.
The compressor must be installed in a well-ventilated area
and with enough space for maintenance tasks. Ensure that
the distances between the compressor and any obstacle
are enough to carry out these tasks. The compressor must
be at least 50cm away from any wall or obstacle.
Avoid discharge pipes and extension cords that are too
long. If possible, the compressor should be installed
nearby the equipments that will consume the compressed
air generated.
Install the compressor in a clean, dry and well-ventilated
location. Never install it in damp places or in a location
where there is a risk of being hit by water projection.
Install the compressor in a room, free of dust, chemicals,
vapours, explosives or flammable gases.
Rubber feet
1. Insert the fixing bolt of the rubber feet into the holes in
the front brackets (8) of the compressed air tank (7);
2. Insert the washers and locknuts on the bolts;
3. Tighten the nuts.
Fixed wheels
1. Align the holes of the wheel (1) and the rear bracket.
Insert the bolt and tighten the nut.
