Idiomas disponibles
Idiomas disponibles
MAKEHOLEFORFAUCET
IMPORTANT:
A I-I/4"
dia. hole is needed to mount the fil-
tered water faucet.
To avoid damaging
the sink,
consult a qualified
plumber
or installer for drilling
procedures
in porcelain
or stainless steel.
1. Select one of the following
options to install the faucet.
Make
sure there is room underneath
to make the needed
connections.
•
Use an existing
sink top hole for spray hose or soap dis-
penser (must be 1-1/4"
in diameter).
•
Drill a new hole in the sink top.
•
Drill a hole in the countertop next to the sink.
2. Check to make sure the filtered
water
faucet
base will sit
flat against
the mounting
surface.
3. If drilling
is needed,
make a 1-1/4"
dia. (minimum)
hole for
the faucet in the mounting
surface.
INSTALL FAUCET BASE
1. Locate the faucet
base (See Fig. 5) and feed the toggle
bolts
down through
the hole until the faucet
base is square against
the mounting
surface
(sink or countertop).
The rubber
gasket
should
be between
the faucet
base and mounting
surface.
2. Tighten the toggle
bolts until the faucet
base is firmly
mounted
to the surface.
Do not overtighten.
CONNECT
TUBE TO FAUCET
1. Mount
the Two-Stage
Drinking
Water
Filter assembly
under
the sink.
Allow
a minimum
of 1-1/2"
under the sumps for
changing
cartridges
(See Fig. 2 on Page 5).
2. Locate the 3/8"
O.D. tubing.
Refer to the "Connect
Tubes"
section on Page 8 and insert one end of the tube all the way
into the 3/8"
quick connect
fitting
on the water
OUT side of
the filter assembly.
See Figure 6.
3. Feed the other end of the tubing
up through
the mounting
hole and faucet
base.
See Figure 6.
4. Refer to the "Cut Tubes to Length"
section on Page 8 and
cut the tube square and to length as needed,
leaving
about
6 inches above the faucet
base.
5. Locate the faucet.
Refer to the "Connect
Tubes" section on
Page 8 and insert the tube all the way into the 3/8"
quick
connect
fitting
on the faucet
bottom.
6. Pull on the tube at each end to be sure it is held firmly
in
both of the quick connect
fittings.
INSTALL FAUCET ON BASE
1. Lower the faucet
onto the base.
See Figure 7.
2. Give the faucet
a 1/4 turn clockwise
to attach the faucet
to
the base.
3. Install battery
in faucet
base (See "Change
Battery"
section
on Page 9) then continue
installation
with Step 3 on Page 8.
faucet base
___
1-1/4" dia. hole
rubber gasket ............ L__
through sink or
toggle bolts
_
countertop
Figure
5
faucet
faucet base
_
Xj_
___
,_
tubing
filter
assembly
water
OUT
Figure 6
faucet
faucet
base
1/4 turn to
connect
faucet
to base
Figure 7
Questions?
Call The Kenmore
Water
Line 1-800-426-9345
or visit KenmoreWater.com
7
