Idiomas disponibles
Idiomas disponibles
Read the following important safety information before using this equipment to avoid
serious injury or death and to avoid damage to equipment or property.
WARNING
ELECTRIC SHOCK HAZARD:
• Plug unit into a properly grounded
electrical receptacle of the correct
voltage, size, and plug configuration. If
plug and receptacle do not match, contact
a qualified electrician to determine and
install proper voltage and size electrical
receptacle.
• Remote mounted control panel must be
mounted on a vertical wall and installed
in vertical position. Mounting control
panel in horizontal position may result
in collection of liquids and lead to an
electric shock.
• Turn OFF power switch, unplug power
cord, and allow unit to cool before
performing any cleaning, adjustments,
or maintenance.
• DO NOT submerge or saturate with water.
Do not allow liquids to spill into unit. Unit
is not waterproof. Do not operate if unit
has been submerged or saturated with
water.
• Unit is not weatherproof. Locate unit
indoors where ambient air temperature is
a minimum of 21°C (70°F) and a maximum
of 51°C (124°F).
• Do not steam clean or use excessive
water on the unit.
• This unit is not "jet-proof" construction.
Do not use jet-clean spray to clean this
unit.
• Do not clean unit when it is energized or
hot.
• Do not pull unit by power cord.
• Discontinue use if power cord is frayed
or worn.
• Do not attempt to repair or replace
a damaged power cord. Cord must
be replaced by an Authorized Hatco
Service Agent or a person with similar
qualifications.
• This unit must be serviced by qualified
personnel only. Service by unqualified
personnel may lead to electric shock or
burn.
IRNGCDCEM1-0123
IMPORTANT SAFETY INFORMATION
ELECTRIC SHOCK HAZARD: Use only
Genuine Hatco Replacement Parts when
service is required. Failure to use Genuine
Hatco Replacement Parts will void all
warranties and may subject operators of the
equipment to hazardous electrical voltage,
resulting in electrical shock or burn. Genuine
Hatco Replacement Parts are specified
to operate safely in the environments in
which they are used. Some after-market
or generic replacement parts do not have
the characteristics that will allow them to
operate safely in Hatco equipment.
EXPLOSION HAZARD: Do not heat unopened
containers of food on unit. Sealed, heated
containers may burst open.
ELECTROMAGNETIC
HAZARD: This unit generates close-range
electromagnetic fields. It has been designed
to meet the applicable standards for non-
interference with other electronic devices.
Make sure ot her electronic devices in the
vicinity, including pacemakers and other
active implants, have been designed to meet
their corresponding applicable standards.
As a precaution, do not operate unit or
come within 305 mm (12ʺ) of unit with a
pacemaker or other active implant.
FIRE HAZARD:
• Make sure to follow the installation
information listed below for specific
induction ranges. If safe distances are not
maintained, discoloration or combustion
could occur.
a. Locate countertop unit a minimum of
51 mm (2") from combustible walls and
materials.
b. Locate built-in unit with a minimum of
38 mm (1-1/2") between sides of unit
and any interior surface.
c. Locate built-in unit with a minimum of
51 mm (2") between front and back of
unit and any interior surface.
d. Locate built-in unit with a minimum of
114 mm (4-1/2") between bottom of unit
and any interior surface.
• Do not obstruct air ventilation openings
on sides and bottom of unit. Unit
combustion or malfunction may occur.
• Do not place unit near or underneath
curtains or other combustible materials.
Items near or above unit could catch fire
causing injury and/or damage to unit.
3
WARNING
INTERFERENCE
