Idiomas disponibles
Idiomas disponibles
Notes:
1. The sensitivity of the motion sensor will increase as the
environmental temperature gets cooler. For best performance,
gently clean the lens with a soft cloth every 1 or 2 months to
ensure maximum sensitivity.
2. For best performance, install fixture at least 8 feet above the
ground. At such a height, the fixture will provide a detection
distance of up to 50 feet at 77 degrees Fahrenheit. (See Fig.7)
3. The sensor detects movement across a detection range of
240 degrees. (See Fig.8)
4. The sensor will be more sensitive to motion across its detection
path than motion directly towards it. (See Fig.9)
5. To reduce possible nuisances, do not mount the fixture near a
heat source like an air conditioner, vent or furnace.
Functions and operations:
Choose a mode by sliding the switch on the bottom of the sensor of the fixture.
(See Fig.10)
1. OFF MODE
The fixture will have the mode switch be set at "OFF" as default.
In "OFF" MODE, the power is turned off to save power and improve battery
charging.
2. TEST MODE (daytime and nighttime operation.)
Slide the "TIME" switch on the sensor head to the "Test" position.
Slide the
"MODE"
switch to
The light turns to high-level brightness (5000K) when motion is detected, and stays on as long as there's motion
being detected. After there's no further motion being detected for 5 seconds, it will revert back to low-level
brightness (2700K), and then turns off automatically after another 5 seconds if no further motion is detected.
3. AUTO MODE (nighttime operation only)
In "AUTO" mode, slide the "Time" switch to the desired time setting (30s/1min/2min). At dusk, the light turns on to
low-level brightness (2700K). When motion is detected, the light turns to high-level brightness (5000K) and stays on
as long as there's motion being detected. After there's no further motion being detected, the high-level brightness
(5000K) will remain on for the predetermined time you set (30s/1min/2min), and then switches back to low-level
brightness (2700K) automatically if no further motion is detected.
The light will turns off automatically at dawn.
4. Energy Saving MODE (nighttime operation only)
In "ES" mode, slide the "Time" switch to the desired time setting (20s/1min/2min). At dusk, the light stays off.
When motion is detected, the light turns to high-level brightness (5000K) and stays on as long as there's motion
being detected. After there's no further motion being detected for the first 10 seconds, the high-level brightness
(5000K) will reduce to low-level brightness (2700K) for the remaining predetermined time you set (30s/1min/2min),
and then turns off automatically if no further motion is detected.
The light will turns off automatically at dawn.
2 TYPES OF POWER METHODS
A. Operate by Solar Power: (See Fig.11)
Power by rechargeable battery inside the battery compartment.
This rechargeable battery can be charged by the solar panel.
(See Fig.11)
"Auto"
or
"ES"
position to operate test mode.
Where you install your fixture is important:
Be sure the light is mounted straight on the wall;
otherwise, the detection distance may be limited.
12.0'
8.0'
10'
Fig.9
Motion
Least sensitive
Page 3 / 5
Fig.7
240
50'
Sensor
Most sensitive
Fig.10
Fig.11
Solar Panel
231130
Fig.8
Motion
Rechargeable
Battery
