Standard Selection; Using A Lithium Battery; User/Installer Drop-Down Menu - IMEON ENERGY IMEON 3.6 Guía De Montaje

6.3.2.1
The selection of the operating standard is possible from the settings/flow management.
The Italian standard IEC 0-21 requires for all inverters that inject power into the public grid a self-test
function in accordance with IEC 0-21. This self test is possible from the button
of the test, the results are recordable.
6.3.2.2
Refer to the battery manufacturer‟s documentation.
FR
FR
1. For Lithium battery using a CAN communication, connect the RJ45
EN
connector wired as presented on figure (stranded cable, minimum
category 6A is recommended) on IMEON‟s CAN port.
ES
Refer to the battery documentation for connection on battery side.
2. Select the battery from the list, then press "OK".
3. Start the battery physically.
4. Once communication is established, the battery will be started automatically.
Note: Inverters with a software version lower than 1.7.7.7 do not benefit from this feature. Please
update your inverter.
5. When the "Battery operating" message is displayed, the battery is operational and communicates
with IMEON.

6.3.3 User/Installer drop-down menu

By clicking on the drop-down menu, several pages are available, in particular:
"WiFi" page: Allows connecting the inverter to Internet. Refer to "Inverter Internet access:
-
MONITORING" Section.
-
"About" page: Allows viewing the inverter‟s ID information, refreshing the parameters of the
-
"Settings" page, restoring the default settings of the inverter and checking if a new inverter
upgrade is available.
82
Manuel d'installation / Installation guide IMEON Inverter/ Guia de montaje – Rev C.12
IMEON INVERTER

Standard selection

Using a Lithium battery

Note: The SSID of the selected network must not contain special characters (@, é, à...).
. At the end
Figure 1 - RJ45 connector