Hendi Arktic 233689 Manual Del Usuario página 10

Congelador de helados
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 61
Cleaning & maintenance
GB
• ATTENTION! Always disconnect the appliance from the pow-
er supply and cool down before storage, cleaning & mainte-
nance.
• Do not use water jet or steam cleaner for cleaning and do not
push the appliance under the water as the parts will get wet
and electric shock might be resulted.
• If the appliance is not kept in a good state of cleanliness, this
can adversely affect the life of the appliance and result in a
dangerous situation.
• Food residues should be regularly cleaned and removed from
the appliance. If the appliance is not cleaned properly, it will
reduce its lifespan and may result in a dangerous condition
during use.
Cleaning
• Clean the cooled exterior surface with a cloth or sponge
slightly dampened with a mild soap solution.
• For reasons of hygiene, the appliance should be cleaned be-
fore and after use.
• Avoid water contacting the electrical components.
• Never immerse the appliance in water or other liquids.
• Never use aggressive cleaning agents, abrasive sponges, or
cleaning agents containing chlorine. Do not use steel wool,
metallic utensils, or any sharp or pointed objects for clean-
ing. Do not use petrol or solvents!
• No parts are dishwasher safe.
Parts
How to clean
External
• Wipe clean with a soft cloth
glass sur-
and a little neutral detergent.
faces
Make sure no water or mois-
ture enters inside the of the
appliance.
Interior glass
• Remove any food deposits.
surfaces
• Wipe clean with a soft cloth
and a little mild detergent.
Glass door
Make sure no water or mois-
ture enters inside the of the
appliance.
Maintenance
• Check the operation of the appliance regularly to prevent se-
rious accidents.
• If you see that the appliance is not working properly or that
there is a problem, stop using it, switch it off and contact the
supplier.
• All maintenance, installation and repair work must be carried
out by specialised and authorised technicians, or recom-
mended by the manufacturer.
Transportation and Storage
• Before storage, always make sure that the appliance has
been disconnected from the power supply and completely
cooled down.
• Store the appliance in a cool, clean and dry place.
• Never place heavy objects on the appliance as this could
damage it.
• Do not move the appliance while it is under operation. Dis-
connect the appliance from power supply when moving and
10
hold it at the bottom.
• Special care must be taken when moving or transporting the
machine due to its heavy weight. With at least 2 persons or
using a cart. Move the machine slowly, carefully, and never
incline more than 45°.
Troubleshooting
If the appliance does not function properly, please check the
below table for the solution. If you are still unable to solve the
problem, please contact the supplier/service provider.
Problems
The appliance
does not
start cooling
after connect to
electrical power
supply.
Cooling is not
enough.
Remark
Dry all
parts well
at last.
Too much noise
LED lamp is not
light up
Warranty
Any defect affecting the functionality of the appliance which
becomes apparent within one year after purchase will be re-
paired by free repair or replacement provided the appliance has
been used and maintained in accordance with the instructions
and has not been abused or misused in any way. Your statutory
rights are not affected. If the appliance is claimed under war-
ranty, state where and when it was purchased and include proof
of purchase (e.g. receipt).
Possible cause
Possible solution
Thermal cut-out
Contact the supplier.
activated
The compressor is
defective.
The power plug/inlet
Check the connec-
is not connected
tion and make sure
properly with the
all the connections
power supply.
are correctly con-
nected.
The appliance is un-
Move the appliance
der strong sunlight
a new location to
radiation or close to
avoid direct sunlight.
a heat source.
The doors are not
Close the doors
properly closed or
properly.
the sealing gasket is
defective.
Too much food is
Place less food in-
placed inside the
side the appliance.
appliance.
Surrounding ventila-
Check that if suffi-
tion is insufficient.
cient ventilation is
provided by allowing
at least 20cm away
from other objects
or wall.
The appliance is not
Check to make sure
placed horizontally.
the appliance is
placed horizontally.
The appliance
Check to make sure
touches surround-
that at least 20cm
ing wall or other
away from other
objects.
objects or wall.
There are some
Contact the supplier.
loose parts inside
the appliance.
The LED is defective
Contact the supplier.
loading