Idiomas disponibles
Idiomas disponibles
ENGLISH
In the box
1. Battery with built-in Wi-Fi and Bluetooth communication
2. Battery terminals (+ and -) with screws (2)
3. Mounting plate with straps and self-tapping screws (6)
4. Manual
Safety instructions
1. Please carefully read this manual before using the battery.
2. Keep the manual and ensure it's accessible for future use.
3. Repairs should only be done by technically qualified personnel.
4. The electrolyte is highly corrosive. Under normal circumstances, contact with the electrolyte is unlikely. In
case of battery damage, avoid direct contact with the electrolyte or powder. If contact occurs, immediately
rinse with plenty of water and seek medical advice.
5. Never short-circuit the + and - poles. The internal BMS (Battery Management System) is protected against
short circuits, but it is strongly advised to avoid such actions to prevent dangerous sparks.
6. Do not open the battery. Opening the battery voids the warranty.
7. Avoid damaging the battery and/or charger housing.
8. Do not use the battery as a starter battery.
9. Do not store the battery in a discharged condition (< 11.5V) for an extended period of time.
10. If the battery remains unused for an extended period of time, charge it every three months.
11. Remember to disconnect the battery terminals or turn off the ground switch during prolonged periods of
inactivity.
12. Store the battery in a cool, dry and ventilated place and keep it out of direct sunlight.
13. Never charge the battery at temperatures below 0°C.
14. Only charge the internal battery in a well-ventilated place.
15. Only charge the battery with a licensed LiFePO4 charger. Using a charger unsuitable for LiFePO4 batteries
can damage the battery. Never use any accessories that are not recommended by the manufacturer.
16. Never use a damaged battery.
17. Ensure that the battery and charger are never covered with clothing or other materials to prevent
overheating.
18. Make sure that the battery is properly secured during transport.
19. Keep the battery out of the reach of children and pets.
Installation safety instructions
1. Never place the battery in high-temperature environments, direct sunlight, near fire or heat sources
exceeding 45°C.
2. Never place the battery in a damp environment with relative humidity above 80%, or where the battery
can come in contact with rain, water or other liquids.
3. Never use the battery in locations with flammable materials or substances.
4. Do not install the battery in an unventilated area, there is a risk of overheating.
5. Never connect the battery in series or parallel to any other type of battery, including wiring from a car.
6. Use cables with the correct diameter. Keep cable connections as short as possible. Utilize reliable cable
clamps and tighten bolts securely.
7. Do not work on the battery or the installation when it is in operation. Let changes to your electrical
installation be done only by qualified electricians.
Installation
Preparation:
1. After unpacking, check all parts for possible damage.
2. Fully charge the battery before first use.
3. Switch off all loads and charging equipment before you start connecting.
4. Install the battery in the location of your choice using the provided mounting plate, straps and self-tapping
screws.
