brondell EasySpa LES-12 Guía De Instalación De Inicio Rápido

Installation:
Step 2
1. Turn off water supply valve and
flush toilet. Hold down handle to
completely empty tank.
NOTE: Do not continue without
completing the above steps. Failure
to do so could result in flooding and
leaking.
2. Disconnect the water supply
line from the toilet tank. Do not
disconnect from water supply
valve on the wall.
3. Insert rubber cone washer into the top
of the cold water T-Valve and connect
to bottom of toilet tank. Ensure the
Step 3
rubber washer is properly seated,
tapered side up. Reconnect water
supply line to the bottom of T-Valve.
4. Remove toilet seat using standard or
Phillips head screwdriver. Set the seat,
mounting bolts, and hardware aside.
5. Connect one end of the bidet hose to
the open side of the installed T-Valve.
6. Place adjustable mounting brackets
Step 5
into the circular holes on the bidet
attachment.
7. Place bidet attachment on the toilet
with the nozzles close to the back
of the toilet, leaving a slight gap
between the toilet and the nozzles.
This will vary by toilet.
8. Make sure the adjustable brackets
line up with the holes in the toilet
fixture. You may need to rotate the
Step 6
adjustable brackets to line them up
properly.
9. Replace the toilet seat on top of
bidet attachment and secure using
original toilet seat hardware. Make
sure to tighten so that the bidet
attachment and seat do not move.
NOTE: Before moving on to the next
step, ensure the handle is in the
"OFF" position to prevent water from
Step 10
spraying out of the bowl.
10. Connect the open end of bidet hose
to the connection under the bidet
attachment.
11. Turn on the water supply valve slowly and wait for 5 minutes to check for leaks.
NOTE: If there is any leaking, check all rubber washers and make sure all water
connections are tight and secure. If necessary, you can use Teflon tape for any
leaking connections.
To use bidet:
1. For a front wash, twist the handle to the left to the "FRONT WASH" icon.
2. For a rear wash, twist the handle to the right to the "REAR WASH" icon.
3. To lower the water pressure, twist the handle back towards the center.
4. To turn off the bidet, return the handle to the "OFF" position.
NOTE: The handle is for control purposes only and is not meant to hold weight.