Idiomas disponibles
Idiomas disponibles
Test/Silence Button
The test/silence button is used to test the unit's electronics and to silence the unit during an alarm.
Short press the test button and you will hear a short beep, indicating that the alarm has entered the test mode. A test push
notification will be sent to your smartphone by the app. Please refer to the "Alarm Testing" section for further information. The
alarm goes back to the standby mode after testing.
NOTE: After a test has begun, the alarm will sound and the LED indicator will flash red. This does not indicate that CO is
present. If you press the test button during an alarm state, the unit will enter the silence mode.
CO Alarm Levels
This X-Sense carbon monoxide alarm is programmed to sound an alarm at the following CO concentrations within the time
periods listed:
30 ppm over 120 minutes,
50 ppm for 60–90 minutes,
100 ppm for 10–40 minutes,
and 300 ppm for 0–3 minutes.
When CO is detected and the alarm sounds, the CO concentration will be displayed on the LCD and a blue backlight will be lit.
The LED indicator will flash red and the alarm will issue 4 short beeps, repeating the cycle every 5.8 seconds. An alarm push
notification will be sent to your smartphone by the app.
04
CO Concentration and Symptoms
The table below shows the effects of different levels of CO poisoning on the body:
Parts per Million (PPM)
Effects on Adults
100
Slight headache, nausea, fatigue (flu-like symptoms).
Dizziness and headache within 2–3 hours.
200
Nausea, frontal headache, drowsiness, confusion and rapid heart rate.
400
Risk to life after over 3 hours of exposure.
800
Severe headaches, convulsions, vital organ failures. Death possible within 2–3 hours.
WARNING
THIS DEVICE IS DESIGNED TO PROTECT INDIVIDUALS FROM ACUTE EFFECTS OF CARBON MONOXIDE EXPOSURE. IT MAY
NOT FULLY SAFEGUARD INDIVIDUALS WITH SPECIFIC MEDICAL CONDITIONS. IF IN DOUBT, CONSULT A MEDICAL
PRACTITIONER.
05
