Idiomas disponibles
Idiomas disponibles
COLD WEATHER OPERATION
CAUTION:
Do not store
in cold environment.
Frost or ice
could form inside
tool affecting
operation
and damaging
tool.
Use a cold temperature
lubricant,
such as ethylene
glycol,
when operating
tool in freezing
temperatures.
Refer to Figure
10.
LUBRICATION
Lubricate tool dally with quality air tool oil. If no air line lubri-
cator is used, place five or six drops of oil into air inlet cap
(Figure 10, Key No. 57) of tool everyday.
MAGAZINE
AND
PISTON-RAM
•
Keep magazine
and nose of tool clean and free of any dirt,
lint or abrasive
particles.
The tip of the ram (Figure
10, Key No. 16) can become
dented
or rounded
over time.
•
Square
off the tip of the ram with a clean,
fine hand
file to
extend
the life of the ram and tool. Fastener
firing will be
more consistent
if the ram tip is kept clean and square.
SAFETY
MECHANISM
CHECK
Inspect
contact
trip safety mechanism
dally for proper
opera-
tion. Do not operate
tool if mechanism
is not operating
properly.
With the red push-button
switch
in the rapid-fire
mode,
per-
form the following
procedures
to test safety
mechanism:
•
Leave
trigger
untouched
wNe
pushing
contact
trip into
workpiece.
Tool
must
not fire.
•
Pull trigger
wNe
contact
trip is clear of work and pointed
away from operator
and others.
Tool
must
not fire.
•
Depress
and hold trigger.
Push contact
trip against
work
where
fastener
is needed.
The tool should
drive only one
fastener
each time the contact
tdp is pushed
against
workpiece.
If contact
trip mechanism
does
not operate
properly,
repair
tool
immediately
through
Sears
Service
Center.
Replace
any damaged
or missing
parts.
Use the parts
list to
order
parts.
REBUILD
KITS
Rebuild
kits are available
as spare
parts,
(see page
9). Tools
should
be rebuilt
if tool fails to operate
properly
after extended
use. See troubleshooting
to determine
required
replacement
parts.
Disconnect
tool
from
air supply
before
attempting
repair
or adjustment.
NOTE:
When
replacing
O-rings
or cylinder,
lubricate
with
grease
before
assembly.
6
