STERWINS PCS 46 Manual De Instrucciones página 36

C – STOP THE ENGINE
1.Release the accelerator trigger to allow the engine to be at idle speed.
Place the switch at "O" position (STOPPED). (F8).
D – STARTING A WARM ENGINE
When you want to turn the chainsaw on again after stopping it, move the switch to (I)
position, leave the air handle at (b) position (normal work position) and pull the starting rope.
If after several attempts it has not started, follow the starting a cold engine steps from step
nº2
CHECKING OIL SUPPLY
F11
(1)
(1) Chain oil
F12
(1)
(1) Adjuster
After starting the engine, run the chain at medium
speed and see if chain oil is scattered off as shown in
the figure. (F11)
The chain oil flow can be changed by inserting a
screwdriver in the hole on bottom of the clutch side.
Adjust according to your work conditions. (F12)
NOTE:
Make sure to refill the oil tank every time when refueling
the unit.
36