Idiomas disponibles
Idiomas disponibles
Installation Steps
Turn off the power at fuse or circuit box
1. Unscrew the two bolt nuts (D), remove the two rubber pads (E) and the mounting plate unit (A) from the backplate.
2. Attach the mounting plate unit (A) to the outlet box by using two mounting screws (B). Adjust the length of the
preinstalled fixture mounting screws if necessary.
Note: Make sure that the fixture mounting screws are lined up horizontally to make the fixture level.
3. Pull out the source wires from the outlet box. Make wire connections using wire connectors (C) as follows:
• Connect the hot wire (black insulation) from the fixture to the black wire from the power source.
• Connect the neutral wire (white insulation) from the fixture to the white wire from the power source.
• Attach the fixture ground wire (bare wire) to the mounting plate unit (A) with the green ground screw, then
depending on local code, connect it to the house ground wire with the wire connector (C).
Carefully put all of the wires back into the outlet box.
4. Attach the backplate of the fixture to the mounting plate unit (A) by inserting fixture mounting screws into set holes
on the backplate, then secure it with two rubber pads (E) and two bolt nuts (D).
Note: With silicone caulk compound, caulk completely around where the backplate meets with the wall
surface to prevent water from seeping into the outlet box.
5. Attach the glass shade to the socket, and secure it with the socket ring.
6. Install the bulb (not included). Check relamping label at socket area or packaging for maximum wattage allowed.
Turn on the power at fuse or circuit box.
The Position of Control Panel
Fig.1
"Time" Knob
Off
Test
Time
Mode
Fig.A
Sensor
View Fig.A
Adjustable
Knob
Fig.2
"Mode" Knob
"Sens" Knob
Auto
PC
Sens
Step 1: Rotate the sensor clockwise or counter-clockwise
at maximum 90 degree to access the adjustable
knobs. (See Fig.1)
Step 2: Adjust time and sensitivity, choose the mode you
want by turning the knob. (See Fig.2 and Fig.A).
Step 3: Restore the sensor to original position by rotating
to the opposite direction. (See Fig.3)
Page 2 / 5
Sensor
Fig.3
231019
