Idiomas disponibles
Idiomas disponibles
5. PANELS MOUNTING
EN
5.1 Overlay door panel layout
The dimensions of the panels are indicated in the
table and drawings on subsequent pages.
Nevertheless, according to the requirements for
aligning with other kitchen structures, the door
panel can be higher than the upper edge of the
refrigerator door.
The panels must be mounted using special
brackets which attach to adjustable devices
provided on the door and drawer and with
brackets that anchor and adjust the panel's
vertical direction.
Brackets and fixing screws are provided with the
appliance and must be applied to the panel as
indicated.
For shaker or framed panel styles, it may
not be possible to affix the upper or lower
leveling brackets unless the cabinet
maker has accommodated their mounting
with additional material on the back of
the panel.
Operate as follows:
To prepare the panels to be mounted on the ap-
pliance, follow these steps, working on the back
of the panel.
Door Panel
>
Draw a vertical center line on the panel from
top to bottom
[ 1
].
1
>
Starting from the bottom edge of the panel,
mark the positioning of the brackets
[ 2
].
2
20
>
Following the corresponding table, mark the
external and then the internal hole
[ 3
].
3
>
Position the brackets on each set of marks to
make sure they are aligned
[ 4
], if you choose to
drill small pilot holes for the screws pay special
attention to not pass through the panel entirely.
[ 5
].
5
4
>
Screw the brackets in place
[ 6
].
6
>
Prepare the appliance door for panel mounting by threading the shoulder bolts into the recessed
receivers and the set screws into the other hole
into the door and not on the visible end. Thread this in far enough that it is flush with appliance door face
so as not to interfere with hanging the panel. You will adjust these later.
7
[ 7
]. Ensure the end with the hex key socket is threaded
Shoulder bolt for hanging brackets on and
for pulling panel in towards the appliance
door.
Set screw used to set depth / z-axis
position of panel and to put opposing
pressure at each fixing point to 'lock'
panel in place.
EN
21
