Idiomas disponibles
Idiomas disponibles
3. PREPARING THE INSTALLATION
EN
TOP COMPRESSORS UNIT:
Electrical connection
Water connection
fig.2 Back of appliance
Operate as follows:
>
Unwind the electric cable and connect it directly to
the wall socket.
>
Make sure the appliance is in the Stand-by condition
and that all ights are off; should it be not so press the
Unit button
to switch it off.
1
fig.3 Front of appliance
>
Firmly tighten with fingers - a tool / wrench should
not be needed to make a proper seal with the rubber
washer in the adapter. Turn on the water and ensure
all connections are not leaking prior to pushing the
unit into the opening.
3.4 Leveling
Adjust the appliance level by means of the front
levelling feet
[ 1 ]
and the rear adjustable wheels
2
2
1
1
18
Operate as follows:
>
If necessary, remove the bottom plinth or grille
(it is kept in position by magnets), adjust the
[ 1 ]
height of the levelling feet
by means of a 17
mm (11/16") wrench.
>
Then adjust the height of the rear wheels by
turning the front adjusting bolts
[ 2 ]
(raise) or counter-clockwise (lower) as it may be
required.
Take care if using a power driver for this and
lower the clutch to prevent damaging the leveling
mechanism.
>
Remount the bottom plinth or grille.
>
If you've accidentally backed out the leveling
rod so that it is disengaged from the leveling
mechanism you will need to pull the appliance
forward to access the rear of the base, locate
the locking nut which will be loose under the
appliance and re-thread the rod through the
leveling plate of the mechanism and reinstall the
locking nut and re-attempt the leveling.
[ 2
].
4. CUTOUT DIMENSIONS
4.1 Cutout dimension for combined installation (for all models except top
compressor units fitted to European-sized cutouts)
clockwise
CORRECT SPACING BETWEEN APPLIANCES SHOWN LATER IN THIS MANUAL.
B
>
Example: if appliance A is 24" and appliance
B is 36" the required opening width will be
24"+36"=60"
A
A
18" model
24" model
18" model
36"(914mm)
42"(1067mm)
24" model
42"(1067mm)
48"(1220mm)
30" model
48"(1220mm)
54"(1372mm)
36" model
54"(1372mm)
60"(1524mm)
EN
B
30" model
36" model
48"(1220mm)
54"(1372mm)
54"(1372mm)
60"(1520mm)
60"(1520mm)
66"(1676mm)
66"(1676mm)
72"(1829mm)
19
