Corrective Action - Craftsman 137.212890 Manual De Instrucciones

I,A WARNING I
To avoid injury from an accidental start, tum the switch OFF and always remove the plug from the power source before
making any adjustments.
• Consult your local Sears Service Center if for any reason the motor will not run.
SYMPTOM
Chop saw wheel
hits base or
work surface.
Cut is not
square.
Chop saw wheel
binds, jams,
burns workpiece.
Rough cuts
Tool vibrates or 1. shakes. 2.
3.
4.
5.
Power head 1.
won't fully rise
or lower guard
won't fully close. 2.
Cutting head hard to 1.
3ulVpush down.
The laser guide will not turn on.
Cutting wheel does not cut
through workpiece.
POSSIBLE CAUSES
1 .The cutting depth
adjustment bolt is set too
deep.
CORRECTIVE ACTION
1. See "Adjusting the Cutting Depth Stop Bolt".
1. Defective wheel.
2. Work not positioned
properly.
3. Excessive wheel pressure.
1. Replace immediately.
2. Check adjustable fence for squareness to blade..
3. Lessen wheel pressure during cutting operation.
1. Improper operation. 1. See "Operation" section.
2. Dull chop saw wheel. 2. Replace wheel.
3. Improper chop saw wheel. 3. Replace with 14 in. abrasive cutting wheel.
Wheel not round.
Wheel damaged.
Wheel loose.
Machine is not secure.
Other.
1. Replace wheel.
2. Replace wheel.
3. Tighten arbor bolt.
4. Mount tool to worksurface.
5. Consult your local Sears Service Center.
Pivot spring or guard
spring not replaced
properly after service.
Part failure.
1. Consult your local Sears Service Center.
Lube needed. 1. See "Maintenance" section.
1. The batteries are drained.
1. Depth stop bolt setting is
incorrect.
1. Replace batteries.
:1. See "Adjusting the Cutting Depth Stop Bolt"
section.