Idiomas disponibles
Idiomas disponibles
FIRST START AND PAIRING REMOTE CONTROL.
(Paired from the factory, unless the remote control comes with the word "Conn")
At the first association between the thermostat and the remote control, the display of the controller
shows the word '' Conn '' until at least one fixed unit is connected.
-DEVICE CONNECTION
While the word '' Conn '' is displayed, move closer to the fixed unit
on the Chronotermostat
screen appears until the thermostat is found or 10 seconds will pass. If the thermostat is not detec-
ted repeat the procedure, bringing the 2 devices closer together and make sure that all the steps
are carried out correctly.
- NEW DEVICES CONNECTION
STANDBY ----> CRONO x 5 sec --- > select with + & - PAIR on RC
screen ----- > PROG
Following the above steps you access the '' Conn '' screen (see previous paragraph).
In this case, if you already have a fixed unit in memory, by pressing [ON / OFF] you can exit the
'' Conn 'screen, if you already have 8 fixed units in memory you will be asked what you want to
delete and replace with the new one ( in order for the complete elimination of thermostat selected,
the new connection must be successful).
-CHANGE THE SELECTED FIXED UNITY
The remote controller uses an only fixed unity at a time. to select another fixed unity:
-From STANDBY: -----> [Chrono] x 5 sec ----- > Select SLCT with [+] & [- ]----> [Prog] to confirm.
- From different Standby status: [Chrono] x 5 sec ------ > select device
(number) with [+] & [-] ------ > [Prog] to confirm.
-RESET Remote Controller
Delete all memorized fixed unity and return factory values of the remote control:
STANDBY ---> CRONO x 5 sec---> select with + & - RSET on screen ---> PROG
The RSET message flashes, press the [Prog] key again to confirm the Reset, or press the [ON / Off]
key or wait to cancel. The thermostat returns to wait for the first connection.
LED green
LED red ON
LED ambar
flashing blue LED
, then press the PROG button on the remote control. The search
ON-Stand-By LED on fixed unity
Stand-By mode
Active heating element
Active thermostat but not the heating element
Pairing LED on fixed unity
The LED flashes during data transmission and when
you press the pairing button to make it visible
ENG
and press the Pairing button
23
