Dishware Drying; Unloading The Dishwasher - Bosch SHE66C Manual De Uso Y Cuidado

Operating the Dishwasher

Dishware Drying

At the end of the cycle the dishwasher will stop
and a period of condensation drying will follow.
After 12 - 15 minutes of drying:
• the cycle countdown display will read "0".
• the "Sanitized" light may appear. See section
on Sanitization for more information.
NOTE: If your household water supply is too hot,
your dishwasher's heating time may be reduced
and the "Sanitized" light may not illuminate. Your
Dishwasher Installation Manual has information
on the recommended temperature for your
household hot water supply.
NOTE: To accelerate and enhance drying,
open the dishwasher door, pull the top rack a
few inches out of the dishwasher, and prop the
dishwasher door against the top rack.
OPTIDRY™
This feature senses when the unit is low on rinse
agent and automatically increases the drying
time.
Additional Drying Heat
With this option you can raise the temperature
of the rinse water and increase the drying time,
which will result in improved drying.
Press and hold the left "Cancel Drain" button,
then press and hold the On/Off button.
When the LED display shows a "0" or a "1",
release both buttons.
To enable the Additional Drying Heat, press the
left "Cancel Drain" button until the LED display
shows a "1".
To disable the Additional Drying Heat, press the
left "Cancel Drain" button until the LED display
shows a "0".
Press the On/Off button to save the setting.
(continued)
"Sanitized" light
When the "Sanitized" light
means that the dishware and kitchenware that
was just washed has been sanitized according
to the requirements of the National Sanitation
Foundation (NSF). For more information on NSF
certification, go to the Wash Cycle Information
section of this manual.
The Cycle Completion Signal
This Cycle Completion Signal is a tone that
sounds when your dishwasher finishes
washing and drying your dishes. You can either
disable the tone, or you can set it at one of two
volumes (your dishwasher leaves our factory with
the tone set on the lower volume).
To change the Cycle Completion Signal Volume:
. Open the dishwasher door far enough to
expose the control buttons.
2. Press and hold the right "Cancel Drain" button
then press and hold the On/Off button.
. When the light on the "Cancel Drain" button
you are pressing illuminates and the tone
begins to sound, release both buttons.
. Press the right-most "Cancel Drain" button
until the tone is either at the desired volume
or is silent.
5. Press the On/Off Button.
6. Shut the dishwasher door. The Cycle
Completion Signal is now set, and you may
wash your dishes as usual.

Unloading the Dishwasher

Unload the bottom rack first.
Unload the silverware basket(s). They are easily
removed for unloading.
Unload the top rack.
If the Extra Tall Item Sprinkler was installed,
return the dishwasher to its normal condition (see
the Loading Extra Tall Items instructions in the
"Loading the Dishwasher" section of this manual).
" appears, it
"