Idiomas disponibles
Idiomas disponibles
BLADE GUARD ASSEMBLY (FIG. I, J, K, L)
To avoid injury from an accidental start, make sure the
switch is in the OFF position and the plug is not
connected to the power source outlet.
1.
Set the blade to maximum height and the tilt to zero
degrees on the bevel scale. Lock the blade lock
knob.
2.
Place the external tooth Iockwasher (2) followed by a
flat washer (3) onto the long bolt (1).
3.
Insert this bolt through the splitter bracket (4) on the
back of the guard assembly.
Fig. I
3
2
.
Place washer (6) on to the pivot rod (5). Insert the
guard assembly into the pivot rod (5) (FIG. J and K)
at the rear of the saw table and tighten.
NOTE: Blade guard and splitter assembly removed
from the splitter bracket illustration for clarity, in
(FIG. J).
Fig. J
.
Check that the nuts (7) that hold the blade guard
assembly (8) to the bracket (4) are tight. Tighten if
necessary. (FIG. K)
Fig. K
6.
Position the blade guard arm (9) (FIG. L) to the
rear.
7.
Using a straight edge, check to see that the blade
guard splitter (10) is aligned with the saw blade (11).
8.
If straightening adjustment is necessary, the
splitter (10) can be shifted to the left or to the right,
and rotated.
9.
When you are certain the splitter is properly aligned
with the saw blade, tighten the bolt (1).
NOTE: The splitter must always be correctly aligned
so that the cut workpiece will pass on either side of
the splitter without binding or twisting to the side.
Fig. L
10
11
I
