Idiomas disponibles
Idiomas disponibles
2=
3=
Screw the Iocknut onto each foot to within 1" (2.5 cm) of the
foot base.
1 "
(2.5era)
t
Screw the feet into the threaded
holes at the front corner of
the washer until the nuts touch the washer. Twist the feet to
install.
NOTE: Do not tighten the nuts until the washer is level.
4. If the washer is not level, move the washer out slightly, tip
back, prop up the front of the washer with the wood block and
adjust the feet up or down as necessary by twisting the feet.
Turn the feet clockwise to raise the washer or
counterclockwise
to lower the washer. Repeat steps
1 through 4 until washer is level.
5. After the washer is in the final location and level, use a 9/16"or
14 mm open-end wrench to turn the nuts counterclockwise
on
the feet tightly against the washer cabinet.
IMPORTANT: If the nuts are not tight against the washer
cabinet, the washer may vibrate.
//
4. Tilt the washer back and remove the wood block. Gently lower
the washer to the floor.
Steps in Final Location
1. Slide the washer to its final location.
2. Tilt the washer forward until the rear of the washer is at least
4" (10.2 cm) off the floor. You may hear the self-adjusting
rear
feet click into place. Lower the washer to the floor.
1. Check the electrical requirements. Be sure that you have the
correct electrical supply and the recommended
grounding
method. See "Electrical Requirements."
2. Check that all parts are now installed. If there is an extra part,
go back through the steps to see which step was skipped.
3. Check that you have all of your tools.
4. Check that the yellow shipping materials were completely
removed from the lower back of the washer.
5. Dispose of/recycle all packaging materials.
6. Check that the water faucets are on.
7. Check for leaks around faucets and inlet hoses.
3=
4"
(10.2 cm)
A. Self-adjusting feet
Check the levelness of the washer by placing a level on the
top edges of the washer, first side to side, then front to back.
Electrical
Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground
prong.
Do not use an adapter.
Do not use an extension
cord,
Failure to follow
these instructions can result
in death,
fire, or electrical
shock.
8. Plug into a grounded 3 prong outlet.
9. Remove the protective film on the console and any tape
remaining on the washer.
10. Read "Washer Use" in the Washer User Instructions.
11. To test and to clean your washer, measure 1/2of the normal
recommended
amount of powdered or liquid detergent and
pour it into the washer basket or detergent dispenser (on
some models). Close the lid. Select any cycle, and then pull
the cycle control knob out to start the washer. Allow it to
complete one whole cycle.
