Idiomas disponibles
Idiomas disponibles
EN
REAR PANEL
1
1.- CH 1, CH 2, CH 3: audio inputs for dynamic microphone (MIC), condenser microphone (PHANTOM
48 V) or line (LINE), balanced combo connectors (XLR and 6.3 mm jack).
NOTE: the CH 1 input has priority by signal level. If a signal is detected on this input, all other signals
will be mute.
2.- MUTE: allows to remotely mute all inputs, except the SIREN signal, with the help of a switch by making
a contact closure. This input is in open circuit, to silence it you must close the circuit.
3.- SPEAKER OUTPUT: 600 W RMS speaker outputs. For speaker connection in low impedance 4-8 Ω
and in high impedance 70-100 V lines. Connect the speaker line between the COM terminal and the
desired impedance or line in volts (V). Use this speaker output if you are not connecting ZONE OUTPUT
zones.
4.- FM: antenna input for FM digital tuner.
5.- Power supply voltage selector.
6.- AUX IN: auxiliary line input, 2 x RCA connectors.
7.- REC OUT: line level recording output. For connection to an amplifier, mixer, power amplifier, etc.,
2 x RCA connectors.
8.- OUTPUT (100 V): terminals to connect the speaker lines of zones 1 to 4 with 600 W RMS maximum
in total for all zones, each independent zone can support a maximum of 600 W RMS. To activate/
deactivate the zones use the front push buttons Z1-Z4. Only loudspeakers with a 100 V line transformer
may be used at these outputs. The total power connected to the loudspeakers must not exceed the
power of the amplifier. Connect the positive of each zone to the corresponding Z1 to Z4 terminal and
the common of all zones to the COM terminal.
9.- GND: grounding screw, to be used in case the socket does not have a built-in grounding screw.
10.- AC power socket.
CONNECTION
IMPORTANT: refrigerate the amplifier properly. To do this, make sure that the place where it is installed has
access to airflow and that the slots in the chassis are free of obstructions.
-
With the amplifier switched off, connect all audio sources. If you are going to use the FM radio, you will
need to connect an FM reception antenna.
-
Connect the speakers to the corresponding low impedance output* (4 Ω + COM or 8 Ω + COM) or
70 V/100 V line* (100 V + COM or 70 V + COM) or zones* (Z1 + COM, Z2 + COM, Z3 + COM, Z4 + COM)
or to the stereo output (REC OUT).
*IMPORTANT: for proper operation and performance of the equipment, use the correct power, impedance
and frequency limits. Before connecting to other equipment, be aware of the conditions required in a
HIGH IMPEDANCE (100 V) and LOW IMPEDANCE installation.. More information can be found at:
2
3
6 7
8
fonestar.com/downloads/install_fonestar_es.pdf
- 4 -
4
5
9
10
